Wolf CT15G-S Installation Manual

INSTALLATION GUIDE

Steamer Module

Contents

Important Note

Wolf Steamer Module . . . . . . . . . . . . . . . . . . . . . . . . . . 3

Steamer Module Specifications . . . . . . . . . . . . . . . . . . 4

Steamer Module Installation . . . . . . . . . . . . . . . . . . . . . 8

Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 10

Features and specifications are subject to change at any time
without notice. Visit wolfappliance.com/specs for the most
up-to-date information.

IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.

o ensure the safe and efficient use of Wolf equipment,

T
please take note of the following types of highlighted
information throughout this guide:

IMPORTANT NOTE highlights information that is especially
important.

CAUTION signals a situation where minor injury or product
damage may occur if instructions are not followed.

WARNING states a hazard that may cause serious injury or
death if precautions are not followed.

Wolf Steamer Module 3

wolfappliance.com/specs

Steamer Module Installation

IMPORTANT NOTE: I

nstallation of the Wolf electric
steamer module must be completed by a qualified
installer.

Read this entire installation guide prior to installation and
save for the local inspector’s reference. The homeowner
should keep this installation guide for future reference.

This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedi­cated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency and amperage ratings are listed on the
product rating plate.

Record the model and serial numbers before installing
the steamer module. Both numbers are listed on the
product rating plate, located on the underside of the
module. Refer to the illustration below.

olf Steamer Module

W

Model Number IS15/S

Serial Number

RATING PLATE

Location of rating plate.

Steamer Module Specifications 4

71/2" (

191)

1

/2" (13)

SIDES

1" (25)

FRONT / BACK

6"

(152)

DRAIN

OUTLET

21" (533)

15"

(381)

Overall Dimensions

STEAMER MODULE

Installation Specifications

Failure to locate the steamer module without the
proper clearances will result in a fire hazard.

IMPORTANT NOTE: Installation of the Wolf electric

steamer module must meet minimum clearance require­ments shown in the installation illustration on page 6.

The Wolf steamer module is intended for indoor use. It is
designed to fit a standard 24"
25"

(635) deep countertop. Before making the countertop

cut-out, verify that the module will clear the side walls of
the base cabinet.

It is recommended that you use a Wolf cooktop ventilation
hood, pro hood or hood liner with the steamer module.
Refer to the Wolf design guide.

IMPORTANT NOTE: Wolf does not recommend the use of

downdraft ventilation with the steamer module.

(610) deep base cabinet with

DRAIN CONNECTION

IMPORTANT NOTE:

It is recommended that the steamer
module be installed with a drain connection and access to
the drain through the base cabinet.

5

The

/8" (16) outlet from the steamer module valve will
accept a drain hose that must flow downward to, and tie
into, an existing sink drain. A separate drain with a freefall
may also be installed. If you do not have a fixed drain
connection, a heat-resistant bucket can be positioned
under the drain outlet to accept the water. The bucket
must have a minimum 2 gallon

(7.6 L) capacity. Refer to the

installation illustration on page 6 for location of the drain
outlet.