Wolf AHP212, AHP636 User Manual
Item #_____________ C.S.I. Section 11420
MODEL: AHP
COUNTER MODEL ACHIEVER HOTPLATE
BASIC MODELS:
AHP212 12" wide AHP424 24" wide
AHP636 36" wide AHP848 48" wide
KEY FEATURES:
➤ Stainless steel sides and control panel
➤ Full width pull out crumb tray
➤ Heavy duty cast iron top grates
➤ 30,000 BTU/hr open burners with lift-off heads
➤ Standing pilot ignition system
➤ One infinite heat control valve for each burner
➤ 4" adjustable legs
➤ 3/4" rear gas connection and gas pressure regulator
➤ One year limited parts and labor warranty
OPTIONAL FEATURES:
➤ Step-up burners. Rear burners elevated 4".
➤ Half hot-top on rear burner, 15,000 BTU/hr input.
➤ 5-5/8", 8", 10", and 11" legs
➤ Stainless steel stand with undershelf and casters
Model AHP424
EXTERIOR DIMENSIONS:
_____" W x 33" D x 12-3/8" working height on 6" adjustable
legs
CSA design certified. NSF listed.
Approved by _______________________
Date: _____________________________
SPECIFY TYPE OF GAS WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 2,000 FT.
CLEARANCES:
Combustible Non-Combustible
Rear 6" 0"
Sides 6" 0"
MODEL: AHP Counter Model Achiever HotPlate
F-36956 (04-07)
Wolf Range Company
Division of ITW Food Equipment Group LLC
(800) 366-9653
www.wolfrange.com
MODEL: AHP
COUNTER MODEL ACHIEVER HOTPLATE
INSTALLATION REQUIREMENTS:
1. A gas pressure regulator sized for this unit is included. Natural
Gas 5.0" W.C. Propane Gas 10.0" W.C.
2. An adequate ventilation system is required for commercial
cooking equipment. Information may be obtained by writing
to the National Fire Protection Association, 1 Batterymarch
Park, Quicy, MA 02169, www.NFPA.org. When writing refer
to NFPA No. 96.
3. These units are manufactured for installation in accordance
with National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition). Copies may be obtained from The American
Gas Association, Accredited Standards Committee Z223
@ 400N. Capital St. NW, Washington, DC 20001, or the
Secretary Standards Council, NFPA, 1 Batterymarch Park,
Quincy, MA 02169-7471.
NOTE: In the Commonwealth of Massachusetts
All gas appliances vented through a ventilation hood or
exhaust system equipped with a damper or with a power
means of exhaust shall comply with 248 CMR.
4. This appliance must be installed with a 6" clearance at both
sides and the rear adjacent to combustible construction.
OVERALL WORKING NO. OF TOTAL APPROX. SHIP
MODEL WIDTH DEPTH HEIGHT HEIGHT BURNERS BTU/HR. WT. (LB/KG)
AHP212 12" 2 60,000 95 lbs./43 kg
AHP424 24" 4 120,000 165 lbs./74 kg
AHP636 36"
AHP848 48" 8 240,000 310 lbs./140 kg
NOTE: In line with its policy to continually improve its product, Wolf Range Company
This appliance is manufactured for commercial use only and is not intended for home use.
F-36956 (04-07)
33" 14-5/8" 12-3/8"
reserves the right to change materials and specifications without notice.
6 180,000 265 lbs./119 kg
Loading...