Model AGT36
Item #_____________ C.S.I. Section 11420
MODEL: AGT SERIES
THERMOSTATIC CONTROL
HEAVY-DUTY GAS GRIDDLE
BASIC MODELS:
AGT24
AGT36 36" w x 24" d griddle plate
AGT48 48" w x 24" d griddle plate
AGT60 60" w x 24" d griddle plate
AGT72 72" w x 24" d griddle plate
KEY FEATURES:
➤ Stainless steel front, sides and 4" front top ledge.
➤ Fully welded stainless and aluminized steel body frame.
➤ 11" low profile cooking height on 4" adjustable legs.
➤ 1" thick polished steel griddle plate robotically welded to
➤ One 30,000 BTU/hr “U” shaped aluminized steel burner and
➤ 3½" wide stainless steel front grease trough.
➤ Large capacity 6⁷⁄₈" wide x 30" deep x 2½" high stainless
➤ ¾" rear gas connection and gas pressure regulator.
➤ One year limited parts and labor warranty.
OPTIONAL FEATURES:
➤ Leg Lengths: 4", 5⁵⁄₈", 8", 10", 11¾"
➤ Chrome-plated cooking surface.
➤ Rear grease trough.
➤ Full or partially grooved griddle plates.
➤ Stainless steel stand with marine edge and casters.
➤ Towel bar.
➤ Full width cutting board.
24" w x 24" d griddle plate
stainless steel back and tapered side splashers.
one modulating thermostatic valve for each 12" of griddle
width. Temperature adjusts from 150° to 450°F.
steel grease drawer.
MODEL: ACHIEVER SERIES Thermostatically Controlled Griddles
CSA design certified. NSF listed.
Approved by _______________________
Date: _____________________________
SPECIFY TYPE OF GAS WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 2,000 FT.
DESCRIPTION:
Low profile heavy duty gas griddle, Wolf Model No. ________.
Stainless steel front, sides and 4" front top ledge. Fully welded
stainless and aluminized steel body frame. 11" low profile
cooking height on 4" legs. 1" thick polished steel griddle plate
robotically welded to stainless steel back and tapered side
splashers. One 30,000 BTU/hr “U” shaped aluminized steel
burner and one modulating thermostatic valve for each 12" of
griddle width. Temperature adjusts from 150° to 450°F. 3½" wide
stainless steel front grease trough. Large capacity 6⁷⁄₈" wide
x 30" deep x 2½" high stainless steel grease drawer. ¾" rear
gas connection and gas pressure regulator.
Exterior dimensions: _____" w x 33" d x 15½" h on 4" legs.
Wolf Range Company
Division of ITW Food Equipment Group LLC
(800) 366-9653
www.wolfrange.com
F-39275 (04-07)
MODEL: AGT SERIES
THERMOSTATIC CONTROL
HEAVY-DUTY GAS GRIDDLE
INSTALLATION REQUIREMENTS:
1. A gas pressure regulator supplied with the unit must be
installed:
Natural Gas 5.0" (127 mm) W.C.
Propane Gas 10.0" (254 mm) W.C.
2. All models require a 6" (152 mm) clearance at both sides
and rear adjacent to combustible and non-combustible
construction.
3. These units are manufactured for installation in accordance
with ANSI/NFPA-70, National Electrical code.
An adequate ventilation system is required for Commercial
Cooking Equipment (NFPA No. 96). Information may be
obtained by writing to the National Fire Protection Association,
Batterymarch Park, Quincy, MA 02169.
4. These units are manufactured for installation in accordance
with National Fuel Gas Code, ANSI-Z223.1/NFPA #54 (latest edition). Copies may be obtained from The American
Gas Association, Accredited Standards Committee Z223
@ 400N. Capital St. NW, Washington, DC 20001, or the
Secretary Standards Council, NFPA, 1 Batterymarch Park,
Quincy, MA 02169-7471.
NOTE: In the Commonwealth of Massachusetts
All gas appliances vented through a ventilation hood or
exhaust system equipped with a damper or with a power
means of exhaust shall comply with 248 CMR.
5. This appliance is manufactured for commercial installation
only and is not intended for home use.
OVERALL WORKING NO. OF TOTAL NO. OF APPROX.
MODEL WIDTH DEPTH HEIGHT* HEIGHT* BURNERS BTU/HR. DRAWERS SHP.WT.
AGT24 24" 33" 15½" 11
AGT36 36" 33" 15½" 11
AGT48 48" 33" 15½" 11
AGT60 60" 33" 15½" 11
AGT72 72" 33" 15½" 11
*These are nominal dimensions and can vary by +1.75" with adjustable legs.
NOTE: In line with its policy to continually improve its product, Wolf Range Company
reserves the right to change materials and specifications without notice.
This appliance is manufactured for commercial use only and is not intended for home use.
F-39275 (04-07)
³⁄₈" 2 60,000 1 285 lbs./129 kg
³⁄₈" 3 90,000 1 400 lbs./181 kg
³⁄₈" 4 120,000 1 480 lbs./218 kg
³⁄₈" 5 150,000 1 650 lbs./295 kg
³⁄₈" 6 180,000 2 790 lbs./358 kg