Wolf 811065, 817992 Installation

Standard Microwave - E Series Trim Installation
STANDARD MICROWAVE CONTENTS
1 Assembly, frame
2 Bracket, mounting (stainless trim only)
6 Screw, #6-18 x 1"
4 Screw, #6-32 x 3/4"
2 Screw #8-15 x 1/2"
1 Duct, bottom
2 Trim, side
4 Tape, black foam
STANDARD MICROWAVE - E SERIES TRIM INSTALLATION
For black trim, proceed to step 4.
1
Position the mounting brackets flush with the cabinet
2
face and base support.
Pre-drill the holes then use six #6-18 x 1" screws to
3
attach the brackets to the cabinet frame.
wolfappliance.com 800.222.7820
Pre-drill two pilot holes and use two #8-15 x 1/2"
7
screws to secure the bottom duct to cabinetry.
Temporarily place the trim over the opening and look
8
for gaps that may be visable between the microwave and trim. Attach foam tape to the microwave to eliminate gaps. The foam tape can be cut to achieve a proper fit.
For stainless trim, attach the frame assembly to the
9
side mounting brackets with four #6-32 x 3/4" screws. For black trim, attach the frame assembly directly to the cabinet with four #6-18 x 1" screws.
Place the microwave onto the bottom duct.
4
Place the microwave assembly close to the cabinet
5
opening and plug the power cord into a properly grounded electrical outlet.
Remove the protective covering from the side trim and
10
install one piece per side.
Insert the microwave assembly into the opening.
6
9020748 REV-A 04/2018
Page 1 of 1
*9020748$REVA*
Loading...