Wolf 809959 Installation

809959 & 820036 - Wolf 24'' Microwave Trim Kit

Installation Instructions For MWTRIM27

815098 / Rev B / September 2011

DUCT

, MICROWAVE

AND TRIM INSTALLATION:

1. Center the bottom duct assembly in opening and secure in place using the #8-15 X 1/2” Truss Head Screws to base of cabinet opening (See Figure 1).

2. Plug power cord in, then carefully guide microwave into opening, lining up feet of microwave with holes in bottom duct assembly, then lower microwave onto duct assembly (See Figures 1and 2).

NOTE: Verify the power cord is not pinched between oven and wall.

CONTAINS:

QTY DESCRIPTION

6 Screws, #6-18x1'' 2 Screws, #8-15x1/2'' Truss HD 1 Bottom Duct Assembly 1 Frame Assembly

Page 1 of 2

QTY DESCRIPTION

2 Panels, Decorative Trim 2 Foam Tape, .375 X 1 X 27 2 Foam Tape, .375 X .5 X 18 1 Installation Instructions

Install the MW24 with a 120V, 60Hz, on a dedicated circuit. This outlet must be checked by a qualified electrician to see if it is wired with correct polarity and is correctly grounded. A GFCI outlet is not recommended as this may cause product operation interruptions.

Feet of Microwave sit in these holes

Figure 1. Bottom Duct Assembly

Figure 2. Placing Microwave in Cabinet Cutout

Frame Assy

Microwave

Duct Assy

OPENING PREPARATION PROCEDURE:

1. Locate properly grounded 3-prong receptacle within 4” (102mm) from the right side and 4” (102mm) up from the bottom of the microwave oven cabinet.

2. The floor of the opening should be constructed of plywood strong enough to support the weight of the oven and floor load (about 100lbs/.45kg). The floor should be level for proper operation of oven. Be sure to check local building code as it may require that the opening be enclosed with sides, ceiling and rear partition. The proper functioning of the oven does not require this enclosure.

809959 & 820036 - Wolf 24'' Microwave Trim Kit

Installation Instructions For MWTRIM27

815098 / Rev B / September 2011

Decorative

Trim

Figure 3. Placing Microwave in Cabinet Cutout

Page 2 of 2

3. Attach the frame assembly directly to the cabinet frame, using four #6-18 x 1'' wood screws. The inside edges of side frames should coincide with the edges of the cabinet cutout (See Figure 3).

NOTE: Always be sure to pre-drill a pilot hole before installing screws to avoid damage to cabinet or trim kit hardware.

NOTE: The two pieces of foam tape are to be used if gaps appear between the frame and the microwave perimeter. If gaps are present, remove the trim and adhere the foam tape to the microwave where needed.

4. Adhere the decorative trim panels to the side brackets so that they are tight to the side and bottom of the frame (See Figure 4).

Decorative

Trim

(Sits tight to

side and bottom

of frame)

Figure 4. Decorative Trim / Frame Assembly