Wolf 820495, 804384, 804385, 804379, 804377 Installation

Bezel Installation Instructions

wolfappliance.com 800.222.7820

INSTALLATION

NOTICE: Depending on the model, additional bezels may
be included with this kit but not utilized.

1 Remove knobs (if installed) then remove existing bezels

by extracting two screws from each bezel. Refer to the
illustration below.

2 Remove new bezels from packaging and discard

packaging material then install new bezels with existing
screws.

3 Reinstall knobs. Using the chart as reference, identify

the icon etched next to each bezel to determine the cor­rect placement. For dual fuel ranges, refer to the illustra­tion below for oven selector bezels placement.

4 If any of the knobs "stick" when pressed, remove the

knob and slightly loosen the two bezel screws. Refer to
the illustration below. Once the proper alignment has
been achieved, tighten screws and reinstall knob.

OVEN SELECTOR KNOB

CAUTION

Do not place bezels in dishwasher. Do not soak or use
abrasive cleaners. To clean, wipe with a damp cloth and
mild detergent and water; rinse and dry.

Icon Text On Knob

Hi-Low and Simmer Hi-Low

100°F to 450°F

Off and Hi

Off and Hi

BEZEL

SCREW

Bezel placement.

ICON

Oven selector knob.
(dual fuel range only)

9006431 REV-A 07/2015

page 1 of 1