Wistron MS2119 Revised Page to WLAN Manual

WireLAN.book Page 1 Tuesday, February 5, 2002 4:02 PM

Regulatory Information

The MPCI3A-20/R Wireless LAN Card must be installed and used in strict accordance
with the manufacturer’s instructions. This device complies with the following
radio frequency and safety standards.

Canada - Industry Canada (IC)

• This device complies with RSS 210 of Industry Canada.

Europe - EU Declaration of Conformity

This device complies with the specifications listed below, following the pro visions
of the EMC Directive 89/336/EEC:

• ETS 300-826

• ETS 300-328 Technical requirements for Radio equipment.

USA - Federal Communications Commission (FCC)

This device complies with Part 15 of FCC Rules. Operation of the devices in an
MPCI3A-20/R Wireless LAN System is subject to the following two conditions:

• This device may not cause harmful interference.

• This device must accept any interference that may cause undesired operation.

1

Exposure to Radio Frequency Radiation

The radiated output power of the MPCI3A-20/R Wireless LAN Card is far below the
FCC radio frequency exposure limits. Nevertheless, the MPCI3A-20/R Wireless LAN
Card shall be used in such a manner that the potential for human contact during
normal operation is minimized.

The transmitter and the antenna are permanently installed inside the notebook, and
are specific for this model (not for generic computer). The antenna of this device
is installed on the corner of the bottom of the LCD display.
The equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This transmitter must not be co-located or operating in conjunction with
any other antenna or tansmitter.

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However , there is no guarantee that