Wintop Electronics WM 796 User Manual

USER MANUAL

™

CLASSICWIRELESS

OPTICAL MOUSE

CAUTION: To use this device properly, please read

the user’s manual before installation

CONNECTING THE MOUSE

1. Open the battery cover and insert 2 x AAA batteries (not included);

Turn mouse on using the On/Off switch found on the bottom

1.5VAAA

1.5VAAA

2. Insert the USB nano receiver into your computer’s USB port

FEATURES

Aluminum wireless optical mouse with 4 keys

Ergonomic design suitable for use in both hands

Compatible with computers featuring standard USB ports

SPECIFICATIONS

Resolution: 800/1200/1600 DPI
Wireless Range: 10M
Dimensions: 4.5" x 2.4" x 1.26"

Designed and distributed by indiCo, LLC
Oberlin, OH 44074 USA
DOURADA™ is a trademark of indiCo, LLC.,
and is registered in the U.S. and Canada.

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.