Wintop Electronics WM 791 User Manual

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:

Reorient or relocate the receiving an　 tenna.
Increase the separation between the equipment and receiver.　
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.　
Consult the dealer or an experienced radio/TV technician for help.

Model: WM-791 USE Manual

Installing Batteries

Storing the Nano Receiver

Instruction Manual

RF2.4GHz Optical Mouse

The RF2.4G Hz optical mouse uses two AAA batteries .

Installing Batteries:

Step 1. Open the back cover.

Step 2. Insert the batteries as show .

Step 3. Replace back cover.

Connecting the Receiver

USB Port

1. Connect the nano receiver ONLY to a USB port on your computer.

Nano receiver

1. The Nano Receiver is stored inside the mouse, in the battery compartment.
To remove the receiver, open your battery compartment and remove the receiver
as per step 1.

2. Once you have finished using the mouse, remove the receiver from your USB port
and replace within the mouse housing as per step 2.

1

Remove the Receiver Store the Receiver

2

Specifications:

1200/1600/2400/3000DP I

Please read these instructions carefully before

first use and retain them for future reference.