Wintop Electronics WM 783 User Manual
1
2
1.5VAAA
1.5VAAA
Acer Wireless Opcal Mouse
Use Manual
Ba ery Co mpart ment co ver
US B Rec eiver
pow er switc h buon
3
Set up the M ouse an d connect to a laptop or PC
1. Open the baery co mpart ment cover at the boom of t he mous e;
remove U SB receiver.
2. Insert two A AA bae ries in to t he baery c ompar tment.
3. Re place t he baery c ompar tment cover.
4. Plug the U S B rece iver into one of your comp uter’s U S B p orts.
Now you are read y to u se the mo use.
4
USB
WM-783
Rem arks:
Long pre ss the powe r switch bu on 2 secon ds to turn off the mo use;
Press th e power switc h buon 1 sec ond to turn o n the mouse.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
This device must accept any interference received, i ncluding interference that may cause undesired
(2)
operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Loading...