Wintop Electronics WM 781 User Manual

Mo d e l : WM78 1

Instruction Manual

Connecting the Receiver

Characteristics

RF2.4GHz Op tical Mouse

CAUT ION:To us e thi s devic e prope rly,plea se read
the us er’s guide b efo re inst allat ion

Installi ng the Batteries

The RF2 .4 GH z op ti cal mouse u se o ne AA al ka li ne batter ie s.

Installing Batteries in the Mouse

Step1 open the upper cover

Step2. Insert the battery as shown inside the battery compartment.

Step 3.Replace upper cover

USB Po rt

1.C onnec t the USB p iug ONLY to U SB port o f the com puter

Abtain t he r ec ei ve r on the cover

1:w hen you w ant use t he mous e,you c an take o ut the re ceive r to comp uter by t he

1

lis t step;

2:w hen you n eed sto p the wor k or to tra vel, yo u can sto re the re ceive r on the mo use
for t he movi ng by the l ist ste p;

Take out t he rece iver

Power- Sa ve f un ct io n:

*Th is mous e is equi pped wi th Trave ling- Power -Save f uncti on.
Whe n you are t ravel ing wit h this mo use, th e LED of th e mouse w ill be sw itche d off
aut omati cally f or the pu rpose o f power -save , but the p re-co nditi on is tha t the
rec eiver i s disco nnect ed with y our not ebook o r PC.

*wh en your m ouse no a ny clik o r scrol l or movi ng,th e mouse w ill cme t o sleep
sta te for th e econo mize af ter abo ut 30 min utes, f or the wa ke up,y ou can cl ick any
but ton for t his

2

1

2

Stor e the rec eiver

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.