Winegard VM-1111, DS-1111 User Manual
WINEGARD
®
Installation Instructions
Models DS-1111, VM-1111
INSTALLATION OF THIS MOUNT NEAR POWER LINES IS DANGEROUS. FOR YOUR
SAFETY, FOLLOW THE INSTALLATION INSTRUCTIONS.
S-PIPE
NOTE: THIS MOUNT IS NOT DESIGNED FOR
APPLICATIONS ON A VERTICAL SURFACE
SUCH AS WALLS, POLES, ETC.
CAUTION: LIMIT SIZE OF TV ANTENNA TO
GS-1000/2000, MS-1000/2000 OR A BOOM
LENGTH OF 40” OR LESS.
STEP 1. Assemble satellite dish and mount per
manufacturers instructions. Do not make fine tuning adjustment at this time.
STEP 2. Remove (2) clamp tightening carriage
bolts from existing clamp bracket.
STEP 3. Attach flat plate to existing clamp bracket
with 1/4 - 20 x 1.25” bolts and install the washers
and nuts.
STEP 4. Adjust azimuth and elevation on satellite
dish for optimum signal strength per manufacturers instructions.
CARRIAGE BOLTS
1/4-20 x 1.25”
NEW CLAMP
BRACKET
EXISTING
CLAMP
BRACKET
1/4” WASHERS
Figure 1
1/4-20
HEX NUTS
EXISTING
CLAMP BRACKET
STEP 5. Tighten all hardware on satellite antenna
mount, including clamp bolt nuts, when the opti-
S-PIPE
mum signal strength is achieved.
STEP 6. Slide S-pipe into new clamp, and adjust
to the approximate desired location. See Figure 2
CARRIAGE BOLTS
1/4-20 x 1.25”
for complete assembly.
STEP 7. Mount off-air antenna to upper mast. Run
coax downlead and secure it at the same time the
DSS wires are installed.
NEW CLAMP
MAKE SURE TO GROUND BOTH ANTENNA/
BRACKET
MOUNTS PER SATELLITE AND OFF-AIR ANTENNA INSTALLATION INSTRUCTIONS.
Figure 2
WINEGARD
Printed in U.S.A. Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601-2000 © Winegard Company 2001 2451765 Rev. 1/04
®
FLAT
PLATE
Loading...