Winegard SK-3003 User Manual 2
DIRECTV® Receiver Setup for SK-3003
The following instructions assume that the TRAV’LER® antenna has found and locked onto satellites 101°,
110° and 119°. There should be an asterisk next to 101°, 110°, and 119° on the TRAV’LER interface.
In most DIRECTV receivers, the setup is done through the “Repeat Satellite Setup” option in your receiver
menu. The following instructions are based upon an H24 receiver. If your receiver differs from the options
shown, you may need to consult your receiver manual. The wording and display used in your receiver
may differ slightly.
For Help, Call 1-800-788-4417
1
3
Press Menu on
your remote,
and then select
Parental, Fav’s &
Setup.
In your receiver
Menu, you will
need to identify
the Satellite
Menu. The
Satellite Menu
will have an
option for
Satellite Setup.
2
4
Select System Setup.
You may be
required to press
the DASH (-)
before proceeding
(underneath #7 on
the remote).
5
7 8
Set Dish Type
for 02: 3-LNB
(18”x20”).
Set the Switch
Type for
02: Multiswitch.
Press Continue.
Errors may be
displayed on the
Installation Status
screen. This is
normal to see one
or two boxes with
an X instead of a .
Select Continue.
6
Your installation
will be verified.
Select Continue.
9
The program
guide will
download.
When the status
bar reaches
100%, press
Continue.
10
The receiver will run
Data Feed and Guide
Feed Tests for a few
moments.
11
You will be
prompted to set
up the remote.
Select Setup
Remote Later to
do this at a later
time.
12
Select
Watch DIRECTV.
Receiver Setup is
now complete.
Winegard and TRAV’LER are registered trademarks of Winegard Company.
DIRECTV is a registered trademark of DIRECTV, Inc., a unit of Hughes Electronics Corp.
Loading...