Wilbur Curtis GEM SS Installation Manual

GEMINI SYSTEMS – CLEANING INSTRUCTIONS

DAILY CLEANING INSTRUCTIONS

WARNING – Hot Surfaces. Avoid injury, allow the warmer deck to
cool before cleaning.

1. Turn off unit at the power
switch, behind the unit. Allow
the brewer to cool.

2. Wipe exterior surfaces with a
damp cloth, removing spills
and debris.

Cleaning the Curtis Gemini Satellite
Brewer.…

To ensure the highest quality, best tasting coffee, your Gemini
Satellite brewer must be cleaned daily after the last batch.

Regular cleaning and preventive maintenance is essential in
keeping your coffee brewer looking and working like new.

CAUTION – Do not use cleansers, bleach liquids, powders or any
other substance containing chlorine. These products promote
corrosion and will pit the stainless steel. USE OF THESE PROD­UCTS WILL VOID THE WARRANTY.

3. Slide the brewcone out and clean it. Thoroughly soap the
sprayhead area with a mild detergent solution.

4. Rinse and dry the brewcone and sprayhead area.

5. Drain drip trays of coffee. Wash the tray and screen with a
mild detergent solution.

6. Dry the tray.

7. Turn on the unit at the front control panel.

WEEKLY CLEANING

1. Turn off unit at the power switch, behind the unit. Allow
the brewer to cool.

2. Remove the sprayhead.
a. Thoroughly clean and rinse both the sprayhead and the
surrounding area.
b. Clean the brewcone rails with a brush soaked with
detergent. Rinse, then dry the area.

GEMINI SATELLITE BREWING SYSTEMS

8. Using a mild detergent, clean inside the Satellite with cloth
or Scotch Brite pad. Remove coffee residue with mild
detergent. Rinse with clear water and dry.

9. Turn on the unit at the power switch behind the unit.

3. Reattach the sprayhead.

4. Twist the faucet handle assembly counter-clockwise to
remove it from the faucet. Disassemble the parts from the
faucet handle.

5. Clean the seat cup. Inspect for cracks or tears.
a. Clean with a mild detergent solution and rinse
the parts. Dry all parts; then assemble.

6. Unscrew the gauge glass cap.
a. Lift out the gauge glass tube.
b. Clean the tube with a gauge glass brush (WC-3640).
c. Clean the upper and lower washers.

7. Dry all parts and assemble.

WILBUR CURTIS COMPANY, INC.

6913 Acco Street, Montebello, CA 90640-5403
Telephone: [phone]
Fax: [phone]

find the latest on the web at

www.wilburcurtis.com

Printed in U.S.A. 1/06 F-3300 rev A