Page 1
Operator: Save these instructions for future use!
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
This adaptor plate assembly is designed for mounting a
Comfort-Set 80 series thermostat to the wall or to a
junction box. The wall cover plate covers the junction box,
wall damage, or old thermostat markings. The adaptor
plate is designed to allow horizontal thermostat mounting,
regardless of junction box orientation.
F61 Series
Adaptor Plate Assembly
INSTALLATION INSTRUCTIONS
DESCRIPTION
Adaptor Plate
All kits may not have adaptor plate or all screws shown.
CAUTION
!
To prevent electrical shock and/or equipment damage, disconnect electrical power
at main fuse or circuit breaker until installation is complete.
CONTENTS
Description ........................................................ 1
Precautions ....................................................... 1
Installation ......................................................... 2
No. 6 X 5/16” Phillips
pan-head screw (2)
F61-2500
Wall Plate
6-32 X 3/4” flat-head
machine screw (4)
PRECAUTIONS
NOTE
This instruction sheet is not intended as a wiring guide.
Refer to the thermostat installation instructions to ensure
proper wiring.
WHITE-RODGERS
EMERSON ELECTRIC CO.
9797 REAVIS ROAD
ST. LOUIS, MISSOURI 63123-5398
www.white-rodgers.com
Printed in U.S.A.
PART NO. 37-6316A
0145
Page 2
INSTALLATION
No. 6 X 5/16” Phillips
pan-head screw (2)
1F8X
Thermostat
FOR 1F8X DIGITAL THERMOSTATS
3
/
6-32 X
” flat-head
4
machine screws
F61-2500
Wall Plate
Subbase
Junction Box
No. 6 X 5/16” Phillips
pan-head screw (2)
Figure 1. Mounting 1F8X digital thermostat to horizontal junction box
Locate and drill two
clearance holes in wall
3
/
6-32 X
” flat-head
4
machine screws
3
6-32 X
” flat-head
/
4
machine screws
F61-2500
Wall Plate
Junction Box
Adaptor Plate
2
Subbase
1F8X
Thermostat
Figure 2. Mounting 1F8X digital thermostat to vertical junction box
Page 3
NOTE
When installing wall cover plate and thermostat directly to
wall, use the pointed screws supplied with the thermostat.
No. 6 X 1” pan-head screws
(supplied with thermostat)
No. 6 X 5/16” Phillips
pan-head screw (2)
Subbase
1F8X
Thermostat
Wall
F61-2500
Wall Plate
Figure 3. Mounting 1F8X digital thermostat to wall
3
Page 4
If you need further information about this product, please write to
White-Rodgers
Emerson Electric Co.
St. Louis, MO 63123-5398
Attention: Technical Service Department
Loading...