Whispair X7P04W5.EP, X7P04B5.IP, X7P04W5.EL, X7P04W5.IL, X7P04B5.IL User Manual

A I R E N G I N E E R E D

OPERATING AND INSTALLATION INSTRUCTIONS

FOR WHISPAIR RANGEHOODS

UTILISING REMOTE FAN MOTOR UNITS

ENVIRONMENTAL TIP

Information on disposal for users

Most of the packing materials are recyclable. Please dispose of those materials through your local recycling depot or by placing them in a appropriate collection bin.

If you wish to discard this product, please contact your local authorities and ask for the correct method of disposal.

CONGRATULATIONS

Congratulations and thank you for choosing a Whispair rangehood.

To avoid the risks that are always present when you use an electrical appliance it is important that the rangehood is installed correctly and that you read the safety instructions carefully to avoid misuse and hazards.

We recommend that you keep this instruction booklet for future reference and pass it on to any future owners.

IMPORTANT INFORMATION

AFTER UNPACKING THE RANGEHOOD PLEASE REVIEW YOUR NEW ITEM TO ENSURE THAT IT HASN’T BEEN DAMAGED IN TRANSIT OR IS MISSING ANY COMPONENTS. FAILURE TO REPORT ANY ISSUE WITHIN 72 HOURS OF RECEIPT OF YOUR ITEM MAY RESULT IN ADDITIONAL CHARGES.

TO AVOID THE RISK OF INJURY OR DAMAGE TO THE PRODUCT IT IS ESSENTIAL TO READ THESE INSTRUCTIONS PRIOR TO INSTALLATION AND USE

1

PRODUCT DESCRIPTION & CARTON CONTENTS

CARTON 1 - HOOD UNIT

You will be supplied with one of the four hood unit options detailed below.

OPTION 1 - INTEGRATED HOOD

MODELS INCLUDED:

X3M06S5, X3M09S5, X3M12S5, X3MD09S5, X3MD12S5 and X3W12S5

INCLUDED IN THE CARTON:

1.Main hood housing including switch control and led lighting

2.Baf e lters

3.Grease trap

4.Cabinet installation screws

5.Operating & installation guide

OPTION 2 - WALL HUNG CANOPY HOOD

MODELS INCLUDED:

X5L09S5, X5S09S5, X5V09S5, X5R09S5, X5R09W5, X5M10S5, X5V12S5, X5N12S5 and X5N15S5

INCLUDED IN THE CARTON:

1.Main hood housing including switch control and led lighting

2.Baf e lters

3.Grease trap

4.Stainless steel chimney (2x)

5.Chimney bracket

6.Wall mounting bracket

7.Fixing screws

8.Operating & installation guide

OPTION 3 - ISLAND HUNG CANOPY HOOD

MODELS INCLUDED:

X7C12S5, X7P04B5, X7P04W5, X7S09S5, X7V09S5, X7R09S5 and

X7N12S5 INCLUDED IN THE CARTON:

1.Main hood housing including switch control and led lighting

2.Baf e lters

3.Grease trap

4.Stainless steel chimney (1x)

5.Ceiling (island) mounting plate

6.Mounting Beams (2x)

7.Threaded rod (4x) and nuts

8.Fixing screws

9.Operating & installation guide

2

OPTION 4 - CEILING MOUNT CASSETTE AND UNIVERSAL HUNG HOOD

MODELS INCLUDED:

X9C12S5, X9B12S5, X9B15S5 and X5C10S5

INCLUDED IN THE CARTON:

1.Main hood housing including switch control and led lighting

2.Baf e lters

3.Grease trap

4.Mounting Beams (2x)

5.Threaded rod (4x) and nuts

6.Fixing screws

7.Operating & installation guide

3

PRODUCT DESCRIPTION & CARTON CONTENTS

CARTON 2 - FAN MOTOR UNIT

You will be supplied with one of the two fan motor unit options detailed below.

OPTION 1 - INLINE FAN SOLUTION (FIG. A)

MODELS INCLUDED:

IL-800 and IP-1140

Unit designed to be located in a roof space and then ducted to an external vent to the outside atmosphere.

INCLUDED IN THE CARTON:

	1.	KLEENAIR Inline fan motor unit
	2.	Mounting bracket
	3.	Mounting screws for vent and fan motor unit
	4.	Pipe Clamps - 200mm (4x)
	5.	200mm Flexi-duct (5 meters in length)
	6.	Aluminium powder coated wall / eave vent	Fig. A
	7.	Foam liner for wall / eave installation

OPTION 2 - EXTERNAL FAN SOLUTION (FIG. B)

MODELS INCLUDED:

EL-800, EP-1140 and EPP-2010.

Unit designed to be mounted externally either on an external wall vertically mounted or penetrating through the roof horizontally mounted.

INCLUDED IN THE CARTON:

1. KLEENAIR External fan motor unit

2. Pipe Clamps - 200mm (2x)

3. 200mm Flexi-duct (5 meters in length)

4. Mounting screws for wall installation

5. Foam liner for wall installation

	OPTIONAL INSTALLATION ACCESSORIES:
	1. HBX200TILE - 200mm Tile Roof Install Kit
	Includes roof ashing for tile roof, 200mm duct mounting
	brackets (2x), threaded rod (2x) and nuts (4x).
	2. HBX200MET - 200mm Metal Roof Install Kit
	Includes roof ashing for metal roof, 200mm duct mounting
	brackets (2x), threaded rod (2x) and nuts (4x).
	3. HBX200DUCT - 200mm Duct Extension Kit
	Includes 200mm Flexi-duct (5 meters length), 200mm inner	Fig. B
	connector and pipe clamps (2x).

4

CONDITIONS OF USE AND MAINTENANCE

This rangehood is a domestic appliance which has been manufactured and tested to comply with Australian and New Zealand Standard AS/NZS 60335.2.31 and is designed to work under Australian and New Zealand conditions. The hoods are designed to remove bi-products of cooking – heat, steam, grease and odour.

This appliance is intended for domestic application only. Any other usage is at the owner’s risk and could be dangerous. The manufacturer cannot be held liable for damage resulting from incorrect or improper use or operation. This unit is approved for electrical safety (Please refer RCM E4759).

WHISPAIR reserves the right to change the speci cation without notice.

All WHISPAIR performance gures are based upon standards developed by the Haus Group, which either comply or are in excess of the government regulated standards.

SAFETY

WARNING: The installation of WHISPAIR rangehoods must comply with the information in this guide. Failure to install the rangehood in accordance with these installation instructions may result in electrical hazards, injury, damage to your appliance and loss of warranty. Speci cally, failure by the installer to install the screws or xing devices in accordance with these installation instructions may result in electrical hazards. Please install the appliance as detailed in these instructions.

This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.

Children should be supervised to ensure that they do not play with the appliance.

There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).

Exhausted air must not be discharged into a chimney or ue which may carry combustion products from other sources.

There is a re risk if cleaning is not carried out in accordance with the instructions.

Baf e lters and grease trap must be regularly cleaned to reduce the risk of re.

CAUTION: Accessible parts may become hot when used with cooking appliances and stainless steel baffle filter edge's can be sharp when handling and cleaning.

Ensure the rangehood is switched off and power source cable unplugged before carrying out maintenance, to avoid any possibility of electric shock.

Always use nonammable materials to minimize the risk of re. Do not ambé under the range hood.

Always cover lit gas burners with pots or pans when cooker hood is in use.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly quali ed persons in order to avoid a hazard.

Please ensure the hood is securely xed to the support as detailed in this guide. The method of xing stated is not to depend on the use of adhesives as they are not a means of reliable xing.

The height of the underside of the hood body must be a minimum of 600mm above an electric cooktop, for a gas cooktop a minimum of 600mm above the highest part of the highest burner and a minimum height of 1200mm above BBQ cookers. If the instructions of the hob specify a greater distance than the minimum detailed, this shall be the minimum height for installation.

5

DUCTING AND EXTRACTION LEVELS

WHISPAIR ducting is designed to ensure optimum performance for your rangehood. Please follow the installation instructions carefully.

Every WHISPAIR rangehood must be ducted to the Inline or Externally mounted KLEENAIR fan motor unit by the use of nonammable ducting. The rangehood must not be ducted into a wall cavity or a ceiling space where a build-up of grease can occur and become a potential re risk. Ensure the external outlet on the KLEENAIR unit is not covered and the air ow is not restricted in any way as this may result in reduced performance.

The duct must at all times have a cross sectional surface area equivalent to the hood outlet. The hood outlet has a circular cross section of 200mm in diameter or an approximate area of 31,400mm . Do not reduce the duct size at any time and avoid sharp bends. If the duct run is longer than six (6) metres, it may be necessary to enlarge the duct size to ensure optimum performance. The manufacturer does not guarantee performance when the duct length is greater than six (6) metres.

Ensure that all ducting is correctly tted and sealed with pipe clips, duct tape or silicone to ensure that fumes do not escape prior to reaching the KLEENAIR fan motor unit.

The WHISPAIR extraction calculations are based upon a 50pa change of head of pressure loss and are used to factor the variance of air ow resistance through the ducting. 50pa is equivalent to approximately four (4) metres (the recommended length) of exi ducting with one gentle bend, which is above and beyond the industry standard of one straight metre of ducting. The KLEENAIR LITE offers a powerful 800 cubic metres per hour (223 litres per second) of air movement. The KLEENAIR PRO offers 1140 cubic metres per hour (317 litres per second) whilst for serious users the KLEENAIR PRO PLUS boasts a market leading 2010 cubic metres per hour (558 litres per second).

THE RECOMMENDED DUCT LENGTH (INSTALLATION DISTANCE) IS 4 METRES.

THE MINIMUM INSTALLATION DISTANCE IS 3.5 METRES.

GENTLE BENDS IN THE DUCTING ARE RECOMMENDED AS IT ASSISTS IN MUFFLING NOISE FROM THE REMOTE FAN UNIT.

Gentle Bend

In Ducting

To Rangehood Unit

6

NOISE LEVELS & EXTRACTION LEVELS

All KLEENAIR fan motor unit operates at maximum external sound pressure level between 43dB(A) and 76dB(A). The internal operation of the systems will have a varying sound level dependent on the style of hood, the motor option selected, the acoustics of the environment and the installation method used. It was established through testing, in accordance with the Australian Standards, that the internal noise level varied between 33dB(A) and 65dB(A) on the air movement settings available.

It is important to understand that whilst WHISPAIR rangehoods offer quieter operational noise levels due to the positioning of the motor remotely to the primary cooking environment, the noise levels as a consequence of air movement or ‘wind’ noise are equivalent to other premium hoods in the Australian and New Zealand market place, although it must be noted that the extraction levels are signi cantly higher.

Extraction Level versus Noise Level

Extraction Level Comparison

Sound Pressure Level

[dB]

70

60

50

40

30

20

10

0	600		1200	1800	[m /hr]
	A.700	B.800	C.1140		D.2010

Cubic Meters / Hour of Air Movement

	[Pa]
	700
	600
Pressure	500
	400
in
Change	300
	200
	100
	0	600		1200	1800	[m /hr]
		A.700	B.800	C.1140		D.2010

Cubic Meters / Hour of Air Movement

A.Standard premium rangehood found in the Aus/NZ market offering 700 m /hr

B.KleenAir Lite Unit offering 800 m /hr

C.KleenAir Pro Unit offering 1140 m /hr

D.KleenAir Pro Plus Unit offering 2010 m /hr

SERVICING

The installation and tting of the rangehood should be done in such a way that will allow the unit to be removed if service is required. Additional costs incurred in the removal, such as damage to walls, are not covered under warranty.

It is expected that the stainless steel is cleaned with a quality non-abrasive stainless steel cleaner. The baf e lters and grease trap are removable and dishwasher safe. It is recommended that these items be cleaned regularly.

The KLEENAIR unit should be checked regularly to ensure that nothing is obstructing the air ow from the housing.

7