Whirlpool WTW5600X, WTW5550X, WTW4950X, WTW4800X, WTW4900X User Manual
...
Top-Loading Washer
3"
41/2"
(114 mm)
PRODUCT MODEL NUMBERS
WTW4900X, WTW5500X,
WTW5550X, WTW5600X,
WTW5640X, WTW5700X,
WTW4800X, WTW4950X,
WTW4910X, WTW5610X
Electrical: A 120 volt, 60 Hz., AC only, 15- or 20-amp,
fused electrical supply is required. A time-delay fuse
or circuit breaker is recommended. It is recommended
that a separate circuit serving only this washer be
provided.
DRAIN SYSTEM
Floor standpipe drain system
41/2"
(114 mm)
Minimum diameter for a standpipe drain: 2" (51 mm).
Minimum carry-away capacity: 17 gal. (64 L) per minute.
Top of standpipe must be at least 39" (990 mm) high;
install no higher than 96" (2.44 m) from bottom of washer.
If you must install higher than 96" (2.44 m), you will need
a sump pump system.
Wall standpipe drain system
30"
(762 mm)
Washer dimensions
(699 mm)
42"
(1067 mm)
14" max.
(356 mm)
OVERALL DIMENSIONS
1
/2"
27
27"
(686 mm)
17"
(432 mm)
For closet installation, with a door,
the minimum ventilation openings
in the top and bottom of the door
are required. Louvered doors with
equivalent air ventilation openings
are acceptable.
(76 mm)
2
48 in.
(310 cm2)
2
24 in.
5"
(126 mm)
41/2"
(114 mm)
1"
See requirements for oor standpipe drain system.
Floor drain system
Floor drain system requires a Siphon Break Kit
(Part Number 285834), 2 Connector Kits (Part
Number 285835), and an Extension Drain Hose
(Part Number 285863) that may be purchased
separately. To order, please see toll-free phone
numbers in your Use and Care Guide. Minimum
siphon break: 28" (710 mm) from bottom of
washer. (Additional hoses may be needed.)
Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation
our products, we reserve the right to change materials and specications without notice. Instructions packed with product. Specications subject to change without notice.
Laundry tub drain system
Dimensions show recommended spacing allowed, except for closet door ventilation
openings which are minimum required. This washer has been tested for installation with
spacing of 0" (0 mm) clearance on the sides. Consider allowing more space for ease of
installation and servicing, and spacing for companion appliances and clearances for walls,
doors, and oor moldings. Add spacing of 1" (25 mm) on all sides of washer to reduce
noise transfer. If a closet door or louvered door is installed, top and bottom air openings in
door are required.
1"
(25 mm)
30"
30"
(762 mm)
(762 mm)
(25 mm)
Minimum capacity: 20 gal. (76 L).
Top of laundry tub must be at least
39" (990 mm) above oor; install
no higher than 96" (2.44 m) from
bottom of washer.
IMPORTANT: To avoid siphoning,
no more than 4.5" (113 mm) of drain
hose should be inside standpipe or
below the top of wash tub. Secure
drain hose with cable tie.
(155 cm2)
3"
(76 mm)
W10240509C
06/2011
Loading...