Whirlpool WGD9051YW, WGD9050XW, WED9050XW, YWED9050XW, WGD9151XW Owner's Manual
...
ELECTRONIC DRYER
®
For questions about features, operation/performance, parts,
Use & Care Guide
accessories, or service, call: 1-800-253-1301
or visit our website at...
www.whirlpool.com
In Canada, call: 1-800-807-6777
or visit our website at...
www.whirlpool.ca
QUICK START GUIDE/
D
RYER USE............PG. 4
Para una versión en español, visite:
www.whirlpool.com
Número de pieza W102996186A
SÉCHEUSE
ÉLECTRONIQUE
Guide d'utilisation et d'entretien
Pour assistance, installation, ou service, composez le : 1-800-807-6777
ou visitez notre site Internet à...
www.whirlpool.ca
TABLE OF CONTENTS
Page
DRYER SAFETY...........................................................................................2
QUICK START GUIDE /DRYER USE .........................................................4
Cycles .......................................................................................................5
Additional Features...................................................................................5
Changing Cycles and Settings .................................................................5
DRYER CARE...............................................................................................6
TROUBLESHOOTING .................................................................................7
WARRANTY .................................................................................................9
ASSISTANCE OR SERVICE..................................................BACK COVER
GUIDE DE DÉMARRAGE RAPIDE/UTILISATION
DE LA SÉCHEUSE....PG. 12
TABLE DES MATIÈRES
Page
SÉCURITÉ DE LA SÉCHEUSE................................................................. 10
GUIDE DE DÉMARRAGE RAPIDE/
UTILISATION DE LA SÉCHEUSE............................................................ .12
Programmes ...........................................................................................14
Caractéristiques supplémentaires......
Modification des programmes et réglages
ENTRETIEN DE LA SÉCHEUSE............................................................... 15
DÉPANNAGE .............................................................................................17
GARANTIE..................................................................................................19
ASSISTANCE OU SERVICE............................... COUVERTURE ARRIÈRE
.................................................... 14
............................................ 14
W10296184B
W10296186B - SP
DRYER SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
You can be killed or seriously injured if you don't immediately
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
follow instructions.
can be killed or seriously injured if you don't
You
instructions.
follow
2
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1/NFPA 54.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National
Electrical Code, ANSI/NFPA 70.
WARNING: For your safety, the information in this manual must be followed to minimize
the risk of re or explosion, or to prevent property damage, personal injury, or death.
– Do not store or use gasoline or other ammable vapors and liquids in the vicinity of this
or any other appliance.
– WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
•
Do not touch any electrical switch; do not use any phone in your building.
•
Clear the room, building, or area of all occupants.
•
Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's
•
instructions.
If you cannot reach your gas supplier, call the re department.
•
– Installation and service must be performed by a qualied installer, service agency, or
the gas supplier.
WARNING: Gas leaks cannot always be detected by smell.
Gas suppliers recommend that you use a gas detector approved by UL or CSA.
For more information, contact your gas supplier.
If a gas leak is detected, follow the “What to do if you smell gas” instructions.
3
QUICK START GUIDE /DRYER USE
WARNING
Explosion Hazard
Keep ammable materials and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
ammable on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or re.
QUICK START GUIDE
WARNING
Fire Hazard
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on
it (including cooking oils).
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using an Air Cycle.
Failure to follow these instructions can result in death
or re.
AccuDry
WARNING: To reduce the risk of re electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS
before operating this appliance.
This Use and Care Guide covers several different models. Your dryer may not have all the cycles and features described.
USING AUTOMATIC CYCLES
Automatic Cycles automatically match
the cycle setting to the type of load and
adjust drying time for optimal performance.
See the Cycles information on the following
pages for more detail on each cycle.
Clean lint screen.
1.
2. Place laundry in the dryer. Shut the door.
3. Press POWER.
4. Select the desired AUTOMATIC cycle.
5. Press and hold START/PAUSE to begin.
Stopping Your Dryer
To stop your dryer at any time
Press POWER.
USING TIMED CYCLES
Use Timed Cycles to set a drying time and
temperature. See the Cycles information on the
following pages for more information.
Clean lint screen.
1.
2. Place laundry in the dryer. Shut the door.
3. Press POWER.
4. Select the desired TIMED cycle.
5. Press TEMP until the desired temperature glows.
6. Press and hold START/PAUSE to begin.
Pausing or Restarting
To stop the dryer at any time
Open the door or press START/PAUSE once.
To restart the dryer
Close the door and press and hold START/PAUSE
4
Cycles
NOTE: Not all cycles are available on all models.
Press the cycle selector button to select the drying cycle that
matches the type of load you are drying. See AUTOMATIC or
TIMED Cycle Settings chart.
Air Dry
Use the Air Dry temperature setting with TIMED DRY cycles for
items that require drying without heat such as rubber, plastic, and
heat-sensitive fabrics. This chart shows examples of items that
can be dried using Air Dry.
20 min
Push to Select
Cycle selection button
Automatic Cycles
AUTOMATIC Cycles allow you to match the cycle to the load you
are drying. See the following AUTOMATIC Preset Cycle Settings
chart. Each cycle dries certain fabrics at the recommended
temperature.
A sensor detects the moisture in the load and automatically
justs the drying time for optimal drying. Drying time will vary
ad
depending on load size, fabric type, and the amount of water
removed by the washer.
NOTE: Dr
cannot be adjusted.
ying tempratures are set for Automatic Cycles and
Automatic Cycle Settings
Automatic Cycles
Load Type
HEAVY DUTY
Heavyweight items, towels, jeans
NORMAL
Corduroys, work clothes, sheets
DELICATE
Lingerie, blouses, washable
woolens
Temperature Est.
Hot 45
Warm 35
Low 30
Cycle
Ti
me
(Minutes)
Timed Cycles
Type of Load Est.
Foam rubber - pillows, padd
Plastic - shower curtains, tablecloths 20 - 30
Rubber-backed rugs 40 - 50
Olefin, polypropylene, sheer nylon 10 - 20
*Reset time to complete drying, if needed.
ed bras, stuffed toys 20 - 30
Time*
(Minutes)
When using Air Dry:
■ Check that coverings are securely stitched.
■ Shake and fluff pillows by hand periodically during the cycle.
■ Dry item completely. Foam rubber pillows are slow to dry.
Additional Features
Cycle Signal
The Cycle Signal produces an audible sound when the drying
cycle is finished. Press CYCLE SIGNAL to turn On or Off at any
time before or during a cycle.
Changing Cycles and Settings
You can change AUTOMATIC Cycles, TIMED DRY Cycles, and the
drying temperature on TIMED DRY Cycles at any time before
pressing START/PAUSE.
■ Three short tones sound if an unavailable combination is
selected. The last selection will not be accepted.
Changing Cycles after starting dryer:
1. Press the POWER button. This ends the current cycle and
turns the dryer OFF.
2. Pr
ess the POWER button again or press the cycle selector to
turn on the dryer.
3. Select th
4. Press and hold START/PAUSE. The dryer starts at the
beginning of the new cycle.
Changing Drying Temperature:
You can change the drying temperature on Timed Dry cycles at
any time by pressing the TEMP button until the desired drying
temperature is lit.
e desired cycle and options.
Use TIMED Cycles to select a specific amount of drying time and
a drying temperature. Press the TEMP button to change the
drying temperature from the default setting. The default drying
temperature is Hot.
TIMED DRY Cycle Settings
TIMED DRY Cycles
Load Type
TIMED DRY
Heavyweight items,
bulky items, bedspreads,
work clothes
*Reset time to complete drying, if needed.
Temperature Cycle Time*
(Minutes)
Hot 60, 40, 20
5
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.
Cleaning the Lint Screen
Every load cleaning
The lint screen is located in the door opening of the dryer.
A screen blocked by lint can increase drying time.
To c lea n:
1. Pull the lint screen straight up. Roll lint off the screen with your
fingers. Do not rinse or wash screen to remove lint. Wet lint is
hard to remove.
3. W
et a nylon brush with hot water and liquid detergent. Scrub
lint screen with the brush to remove residue buildup.
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Replace screen
in dryer.
Cleaning the Dryer Interior
To clean dryer drum:
1. Make a paste with powdered laundry detergent and very
warm water.
2. Apply paste to
OR
Apply a liquid, nonflammable househ
area and rub with a soft cloth until all excess dye and stains
are removed.
3. Wip
4. T
NOTE: Garments that contain unstable dyes, such as denim blue
jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will not
stain future loads of clothes. Dry unstable dye items inside out to
avoid transfer of dye.
e drum thoroughly with a damp cloth.
umble a load of clean cloths or towels to dry drum.
a soft cloth.
old cleaner to the stained
2. Push the lint screen firmly back into place. IMPORTANT:
■ Do not run the dryer if the lint screen is loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
■ If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. See “Venting
Requirements.”
As needed cleaning:
Laundry detergent and fabric softener residue can build up
on the lint screen. This buildup
for your clothes, or cause the dryer to stop be
completely dry.
Clean the lint screen with a nylon brus
frequently, if it becomes clogged due to a residue buildup.
can cause longer drying times
fore your load is
h every 6 months, or more
To w as h :
1. Roll lint off the screen with your fingers.
et both sides of lint screen with hot water.
2. W
Removing Accumulated Lint
From Inside the Dryer Cabinet:
Lint should be removed every 2 years, or more often, depending
on dryer usage. Cleaning should be done by a qualified person.
From the Exhaust Vent:
Lint should be removed every 2 years, or more often, depending
on dryer usage.
Vacation, Storage, and Moving Care
Non-Use or Storage Care
Operate your dryer only when you are at home. If you will be on
vacation or not using your dryer for an extended period of time,
you should:
1. Unplug dryer or disconnect power.
2. Clean lint screen. See “Cleaning the Lint Screen.”
Moving care
For power supply cord-connected dryers:
1. Unplug the power supply cord.
ke sure leveling legs are secure in dryer base.
2. Ma
3. Us
e masking tape to secure dryer door.
6
Loading...