Whirlpool WFG770H0FZ, WFG745H0FE, WFG745H0FH, WFG745H0FS, WFG540H0EE Dimension Guide

...

30" (76.2 cm) Freestanding Gas Range

PRODUCT MODEL NUMBERS

WFG540H0A

WFG540H0E

WFG710H0A

WFG714HLA

WFG715H0E

WFG720H0A

Type of Gas

Natural Gas:

■ This range is factory set for use with Natural gas. See “Gas

Conversions” section. The model/serial/rating plate is located on the oven frame behind the top right side of the oven door has information on the types of gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier.

LP gas conversion:

Conversion must be done by a qualiﬁed service technician.

No attempt shall be made to convert the appliance from the gas speciﬁed on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. See “Gas Conversions” section.

Gas Supply Line

■ Provide a gas supply line if

/4" (1.9 cm) rigid pipe to the range location. A smaller pipe on longer runs may result in insufﬁent gas supply. With LP gas, piping or tubing size can be 1/2" (1.3 cm) minimum. Usually, LP gas suppliers deteremine the size and materials used in the system. NOTE: Pipe-joint compounds that resist the action of LP gas must be

WFG745H0F

WFG770H0F

PRODUCT DIMENSIONS

A. 277/8" (70.8 cm) max. depth with handle

B. 36" (91.4 cm) cooktop height (max.) with leveling legs screwed all the way in*

C. 467/8" (119.1 cm) overall height (max.) with leveling legs screwed all the way in*

E. 257/16" (64.3 cm) depth.

D. 297/8" (75.9 cm) width

Back of range to front of cooktop**

F. Model/serial rating plate (located on the oven frame behind the top right side of the oven door)

IMPORTANT: Range must be level after installation. Follow the instructions in the “Level Range” section. Using the cooktop as a reference for leveling the range is not recommended.

* Range can be raised approximately 1" (2.5 cm) by adjusting the

leveling legs.

** Front of door and drawer may extend further forward depending on

styling.

CABINET OPENING DIMENSIONS

used. Do not use TEFLON®† tape.

Flexible metal appliance connector:

■ If local codes permit, a new CSA

design-certiﬁed, 4 to 5 ft (122 to 152.4 cm) long, 1/2" (1.3 cm) or 3/4" (1.9 cm) I.D., ﬂexible metal appliance connector may be used for connecting range to the gas supply line.

■ A

/2" (1.3 cm) male pipe thread is needed for connection to the female

pipe threads of the inlet to the appliance pressure regulator.

■ Do not kink or damage the ﬂexible metal tubing when moving the

range.

■ Must include a shutoff valve:

The supply line must be equipped with a manual shutoff valve. This valve should be located in the same room but external to the range

opening, such as an adjacent cabinet. It should be in a location that allows ease of opening and closing. Do not block access to shutoff valve. The valve is for turning on or shutting off gas to the range.

A. Gas supply line B. Shutoff valve “open” position C. To range

A. 18" (45.7 cm) upper side cabinet to countertop B. 13" (33 cm) max. upper cabinet depth C. 30" (76.2 cm) min. opening width D. For minimum clearance to top of cooktop, see NOTE *. E. 301/8" (76.5 cm) min. opening width F. The shaded areas are recommended for installation of rigid gas pipe. G. 11" (27.6 cm)

†®TEFLON is a registered trademark of E.I. Du Point De Nemours and Company.

Electrical

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided.

H. 17" (43.2 cm) I. 2" (5.1 cm) J. 41/2" (11.4) K. 3" (7.6 cm) min. clearance from both sides of range to side wall or

other combustible material. L. Grounded outlet M. Cabinet door or hinges should not extend into the cutout.

Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height.

IMPORTANT: If installing a range hood or microwave hood combination above the range, following the range hood or microwave hoods combination instructions for dimensional clearances above the cooktop surface.

* NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet

is covered by not less than 1/4" (0.64 cm) ﬂame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.

A freestanding range may be installed next to combustible walls with zero clearance.

Because Whirlpool Corporation includes a continuous commitment to improve our products, we reserve the right to change materials and speciﬁcations without notice.

Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Speciﬁcations subject to change without notice.

Page 1 of 1

W10553363C

08/30/2016