Whirlpool WEE510SAGB Dimension Guide

Electric Range Installation Instructions

PRODUCT MODEL NUMBERS

WEC310SAG WEE510SAG

INSTALLATION REQUIREMENTS

Product Dimensions

These instructions cover several models. Your model may appear
different from the models depicted. Dimensions given are maximum
dimensions across all models.

A

B

C

Cabinet Dimensions

Cabinet opening dimensions shown are for 25" (64.0 cm) countertop
depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop
height.

IMPORTANT: If installing a range hood or microwave hood combination
above the range, follow the range hood or microwave hood combination
installation instructions for dimensional clearances above the cooktop
surface.

Range may be installed next to combustible walls with zero clearance.

D

E

F

A. 13/16" (3.0 cm) height from cooktop
to top of vent

B. 297/8" (75.9 cm)
C. Model/serial/rating plate (located

behind the oven door on the top
right-hand side of the oven frame)

D. 34" (86.4 cm) height to top of
cooktop edge with leveling legs
screwed all the way in*

IMPORTANT: Range must be level after installation. Follow the
instructions in the “Level Range” section. Using the cooktop as a
reference for leveling the range is not recommended.

* Range can be raised approximately 1" (2.5 cm) by adjusting the

leveling legs.

E. 2825/64" (72.1 cm) max. depth
from front of console to
back of range

F. 291/64" (73.7 cm) max. depth
from handle to back of
range

B

D

C

A

E

K

G

H

I

F

J

I

A. 18" (45.7 cm) upper side cabinet to countertop
B. 13" (33 cm) max. upper cabinet depth
C. 30" (76.2 cm) min. opening width
D. For minimum clearance to top of cooktop, see NOTE*.
E. 30" (76.2 cm) min. opening width
F. The shaded area is recommended for installation of grounded

outlet.
G. 13¹⁄8" (33.3 cm)
H. 7¹¹⁄16" (19.5 cm)
I. 4¹³⁄16" (12.2 cm)
J. 3¹¹⁄16" (9.4 cm)
K. Cabinet door or hinges should not extend into the cutout.

* NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet

is shielded by not less than 1/4" (6.4 mm) flame retardant millboard
covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)
stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking

platform and the bottom of an uncovered wood or metal cabinet.

Because Whirlpool Corporation includes a continuous commitment to improve our
products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

Page 1 of 2

Ref. W11097823A

06/06/17