GB WATS 5341
A. Temperature Selection Knob
B. “Spin Speed Reduction” Button
C. “On/Off” Button
CBA
❉
: Option
Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is
restricted to 800 rpm in this programme,
even if the spin speed reduction button is
not pressed.
3)
For improved garment care, spin speed is
zero in this programme.
Programme
Cotton with prewash
Koch-Buntwäsche mit
Vorwäsche
Synthetic with prewash
Pflegeleicht mit Vorwäsche
Delicate with prewash
Feinwäsche mit Vorwäsche
Cotton
Koch- Buntwäsche
Cotton short
Koch- Buntwäsche kurz
Synthetic
Pflegeleicht
Synthetic short
Pflegeleicht kurz
Delicate
Feinwäsche
Wool
Wolle
Handwash
Handwäsche
Rinse + Gentle Spin
Spülen + Schonschleudern
Rinse + Spin
Spülen + Schleudern
Spin
Schleudern
Gentle spin
Schon- schleudern
Drain
Abpumpen
Care
Labels
—
—
—
—
Type of wash / Notes
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of
cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of
cotton and linen.
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc.,
made of cotton and linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen,
Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and
blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as
machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long.
Same as the last two rinses and the final spin in the “Synthetic” programme.
Programme for treating wash with starch or softener.
Same as the last rinse and the final spin in the “Cotton” programme. In this
programme spinning is intensive.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton”
programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool”
programme.
Drain only - no spinning. Alternative method of terminating programme after
“Rinse Hold”.
N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.
Max.
load
kg
5.0
2.0
1.5
5.0
3.0
2.0
1.5
1.5
1.0
1.0
2.0
5.0
5.0
2.0
—
Detergents and additives Special Options
Prewash
Yes
Yes
Yes
—
—
—
—
—
—
—
Main
Wash
1)
1)
1)
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Softener
❉❉❉❉ ❉
❉❉❉❉❉
❉
❉❉❉❉ ❉
❉❉❉❉ ❉
❉❉❉❉❉
❉❉❉❉❉
❉
❉
❉
——❉
——
❉❉
———
Easy
Ironing
Leicht
Bügeln
Intensive
Rinse
Intensiv
Spülen
——
——
——
——
——
—
❉
——
Rinse
Hold
Spül-
stopp
❉❉
❉❉
❉❉
❉
❉❉
❉❉
——— ———
Spin Speed
Reduction
Drehzahl-
reduzierung
—
❉
❉
Tempera-
2)
2)
2)
2)
2)
2)
3)
2)
2)
ture
°C
Max.
Spin
Speed
rpm
Max. 95 1000
Max. 60 800
Max. 40 800
Max. 95 1000
Max. 60 1000
Max. 60 800
Max. 60 800
Max. 40 800
Max. 40 800
Max. 30
—
—
—
—
—
800
1000
1000
800
2)
2)
2)
2)
2)
2)
3)
2)
2)
——— ——— — ——
5019 412 00059
CONSUMPTION DATA
Programme
Cotton
Cotton
Cotton
Synthetic
Synthetic
Delicate
Wool
Handwash
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60° C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump
drains the water out.
Temperature Selector
(°C)
95 5.0 63* 1.80 2:05
60 5.0 55 0.95 2:05
40 5.0 55 0.55 2:05
60 2.0 56 0.80 1:35
40 2.0 50 0.40 1:30
40 1.5 60 0.55 0:50
40 1.0 60 0.50 0:40
30 1.0 60 0.30 0:50
PREPARATION OF WASH CYCLE
1. Load the machine, close the drum flaps and
check that they are properly locked.
2. Add detergents and additives into the
dispenser to no more than the “MAX” level
mark, as follows:
• Programme with pre and
main wash
• Main wash programme
without prewash
• Fabric softeners and
conditioners
• Stain remover agents
• Anti-scale agents
(if necessary)
3. Turn the programme selector knob to the
desired programme.
4. Turn the temperature selector knob to
the desired temperature.
5. Press the spin speed reduction button, if
desired.
• If you want to cancel the final spin, select
the rinse hold option and drain the water
after the cycle has finished (see Appliance
in “Rinse Hold”).
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
SELECT THE DESIRED OPTION
Selecting or deselecting an option can be
done at any time during the programme.
The option will be applied as long as the
corresponding programme phase has not
been executed yet.
“Easy Ironing” button
• Can be used together with “Cotton” and
“Synthetic” programmes to make ironing
easier.
• Incr e ases the water quantity in rinsing and
the clothes are spun in a softer manner.
“Intensive Rinse” button
• One rinse cycle is added to ensure a more
intensive rinse.
• This option is particularly suitable for areas
with very soft water, washing baby linen
and people with detergents allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the f inal spin cycle to
avoid creasing and prevent colours from
fading.
• This option is particularly recommended for
the “Synthetic” or “Delicate” programmes.
• This function is particularly useful if you
want to postpone spinning to a later time,
or if you want to drain only.
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
programme will terminate automatically
with the selected spin cycle.
• If you do not wish to spin the clothes, press
the “On/Off” button, turn the programme
selector knob to the “Drain” programme
and press the “On/Off” button again.
PROGRAMME START
Turn on the tap and press the “On/Off” button.
The indicator light of the “On/Off” button
lights up.
Note: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where
it was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop
position “ ”.
1. Press the “On/Off” button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the door to unlock (about 1
minute).
5. Open the door and the drum flaps and
unload the machine.
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
1. Switch off the machine by pressing the
“On/Off” button.
2. Select the new programme.
3. Start programme by pressing the “On/Off”
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrup t the
programme for a certain time and continue it
later:
1. Press the “On/Off” button.
2. After the desired pause, press again the “On/
Off” button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
“On/Off” button.
2. Set the programme selector to “Drain”.
3. Press the “On/Off” button again to start the
“Drain” programme.
5019 412 00059