Whirlpool WATS 2000 PROGRAM CHART
GB WATS 2000 PROGRAMME CHART
Programme
Cotton 95°
with prewash
Synthetic 60°
with prewash
Delicate 40°
with prewash
Cotton
95° - 60° - 40°
Synthetic
60° - 40°
Delicate 40°
Wool 40°
Handwash 30°
Rinse & Gentle Spin
Rinse & Spin
Spin
Gentle spin
Drain
B
A
Koch-Buntwäsche 95°
mit Vorwäsche
Pflegeleicht 60°
mit Vorwäsche
Feinwäsche 40°
mit Vorwäsche
Koch-Buntwäsche
95° - 60° - 40°
Pflegeleicht
60° - 40°
Feinwäsche 40°
Wolle 40°
Handwäsche 30°
Spülen & Schon Schleudern
Spülen & Schleudern
Schleudern
Schon Schleudern
Abpumpen
Care
Labels
—
—
—
—
—
A.“Start” Button
- lights up when activated B.Programme sequence indicator
C.“Spin Speed Selection” Button
D.“On/Off” button
C
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of
cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc.
made of cotton and linen.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon).
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as
machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Programme for treating delicate laundry with starch or softener.
Programme for treating cotton or linen laundry with starch or softener.
Programme to spin cotton or linen laundry intensively with maximum spin speed.
Programme to spin delicate laundry gently with a restricted spin speed.
Drain only - no spinning. Alternative method of terminating programme after “Rinse
Hold”.
D
Type of wash / Notes
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is
restricted to 700 rpm in this programme.
3)
For improved garment care, spin speed is
zero in this programme.
Max.
load
kg
5.0
2.0
1.5
5.0
2.0
1.5
1.0
1.0
2.0
5.0
5.0
2.0
Prewash Main
Detergents and additives Special Options Max.
Wash
Yes
Yes
Yes
—
—
—
—
—
1)
1)
1)
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
——
——
Softener Bleach Eco
Öko
❉❉❉❉
❉
❉
—
—— —
❉❉
❉❉❉❉
❉
❉
❉
❉
❉
❉
—
—— —
—— —
—— —
——
——
❉❉
Half
Load
Halbe
menge
❉
❉
——————
——————
Spin
Speed
rpm
1000
700
700
1000
700
700
700
—
700
1000
1000
700
2)
2)
2)
2)
2)
3)
2)
2)
—— ——————
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
5019 412 10050
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 95 5.0 66* 1.80 2:05
Cotton 60 5.0 55 0.95 2:05
Cotton 40 5.0 55 0.60 2:05
Synthetic 60 2.0 56 0.80 1:30
Synthetic 40 2.0 56 0.40 1:20
Delicate 40 1.5 60 0.55 0:45
Wool 40 1.0 60 0.50 0:40
Handwash 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the
values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more than the
“MAX”
level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Press the
The lamp of the
“On/Off”
button.
“Start”
button flashes.
4. Turn the programme selector knob to the
desired programme. The lamp of the
programme’s standard spin speed lights up.
Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.
“Eco” button
• The duration of the wash is extended and the
max temperature reduced to save up to 40% of
energy compared to a normal wash but
maintaining good washing results.
“Half Load” button
• Can be used for small loads and lightly soiled
laundry.
• Reduces the water consumption especially
during the rinses.
Spin speed selection button
• Every programme has an automatically preset spin
speed.
• Press the button to set another spin speed.
•
If spin speed “0” is selected, the final spin is
cancelled
and the programme ends with a drain
cycle.
PROGRAMME START
Verify that the appliance is switched on.
Turn on the tap and press the
The indicator lamp of the
“Start”
“Start”
button stops
button.
flashing and lights up.
: If there is a power interruption or if the
Note
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
END OF WASH CYCLE
• The “End” lamp of the programme sequence
indicator lights up.
1. Press the
“On/Off”
button to switch off the
machine.
2. Turn the tap off.
3. Wait for the lid to unlock (about 1 minute).
Open the lid and the drum doors and unload
4.
the machine. Leave the lid open for some time
to allow the inside of the appliance to dry.
CHANGE THE PROGRAMME DURING
THE WASH CYCLE
1. Switch the appliance off by pressing
“On/Off”
.
2. Turn the programme selector knob to the
new programme.
3. Switch the appliance on again by pressing
“On/Off”
. The “Start” button flashes. If
necessary, select additional options and
different spin speed.
4. Start programme by pressing the
“Start”
button.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it
later:
1. Press the
“On/Off”
button.
2. After the desired pause, press again on the
“On/Off”
button.
CANCEL PROGRAMME
1. Switch off the appliance by pressing
“On/Off”
.
2. Turn the programme selector to “Drain”.
3. Switch the appliance on again by pressing
“On/Off”
. The lamp of the
“Start”
button
flashes.
4. Press the “Start” button to start the “Drain”
programme.
5019 412 10050
Loading...