GB PWA 530
“On/Off”
Max.
load
Programme Type of wash / Notes
Cotton with prewash
Cotton
Coulored
Quick Wash Blouses, shirts, cotton blouses, dark coloured terry towelling, jeans etc., lightly soiled. 5,0 – Yes
Synthetics
Rinse + Spin
Heavily soiled sheets, tablecloths, underdothes, shirts etc., in hard wearing and high temperature
resistant cotton.
The maximum load for heavily soiled washing is 3,5 kg.
Moderately soiled sheets, tablecloths, underdothes, towels etc., in hard wearing and high emperature
resistant cotton.
Averagely soiled blouses, shirts etc., made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or
cotton blends.
Lightly soiled shirts, blouses etc., made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or
cotton blends.
This programme allows starch or softener to be added.
It is followed by an intensive spin cycle.
Pre-
wash
kg
5,0 Yes
5,0 – Yes
2,0 – Yes
2,0 – Yes
5,0 – –
Programme duration figures (guideline) are valid
for maximum temperature wash with no special
functions.
i : option / Yes: dosing required
1)
Do not use liquid detergents.
Detergents and additives Option Tempera-
Main
wash
1)
Softener Bleach Half load
Yes
i i i
i i i
i
i
i
i
– – Max. 60 500 100
–
–
–
i
i
i
ture
selector
°C
Max. 90 500 130
Max. 90 500 115
Max. 40 500 85
Max. 40 500 70
Min. 500 20
Maximum
Spin
speed
rpm
Programme
time
approx.
min.
Spin Programme for intensive spin cycle. 5,0 – – – – – – 500 15
Delicate Delicate fabrics and curtains (dresses, skirts, shirts, blouses, etc.). 1,5 – Yes
Wool Machine washable woollens with pure new wool label. 1,0 – Yes
Rinse + Spin
Spin Programme for gentle spin cycle. 1,5 – – – – – – 500 10
Drain Drain only, without spin cycle. – – – – – – – – 5
This programme allows starch or softener to be added.
It is followed by a gentle spin cycle.
1,5 – –
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
i
i
i
– – Max. 40 500 55
– – Max. 40 500 45
– – Min. 500 15
5019 812 10015
ENERGY AND WATER CONSUMPTION DATA
Programme
Temperature
selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme time
(min)
Cotton 90 5,0 72 1,80 115
Cotton 60 5,0 72 1,15 115
Coloured 60 2,0 60 0,80 100
Coloured 40 2,0 60 0,40 100
Quick wash + 1/2 load 40 2,5 54 0,50 85
Synthetics + 1/2 load 30 1,0 54 0,30 70
Delicate 40 1,5 70 0,65 55
Wool 40 1,0 70 0,55 45
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard EN 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account
the household conditions applicable at that time.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE PRESS ANY DESIRED OPTION BUTTON(S)
1. Close the drum flaps and check that they are
properly locked.
2. Add detergents and additives into the dispenser
to no more then the “MAX” level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
“Half load” button
• Reduces the water consumption in the “Cotton”
and “Synthetics” programmes especially during
the rinse.
• Especially suitable for lightly soiled or small
loads (reduces the quantity of detergents).
• Not suitable for high temperature programmes.
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
PROGRAMME START
Open the water inlet tap and press the “On/Off”
button. The pilot lamp lights up.
3. Turn the programme selector knob clockwise
to the desired programme.
4. Turn the temperature knob to the required
temperature.
DOOR LOCK
During the running programme, the door cannot be
opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical power
failure occurs, the door unlocks automatically after
about 1 minute.
PROGRAMME END
• The programme selector knob is at “STOP”,
the pilot lamp lights.
1. Press the “On/Off” button, the pilot light goes
out.
2. Cancel the options by pressing the appropriate
buttons.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload
the machine.
SELECTING A NEW PROGRAMME, SPIN
SPEED, OPTIONS AFTER PROGRAMME
START
1. Press the “On/Off” button to switch off the
appliance.
The pilot light goes out.
2. Select the new programme, temperature and
options.
3. Press the “On/Off” button to switch on the
appliance.
The pilot light lights.
TO STOP, RESET A PROGRAMME BEFORE
THE END
1. Press the “On/Off” button to switch off the
appliance.
The pilot light goes out.
2. Set the programme selector on “Drain”.
3. Press the “On/Off” button to start the “Drain”
programme.
Only open the door when the programme
selector is at “STOP” and the door is unlocked
(after approximately 1 minute).
NOTES AND INDICATIONS FOR USE
• After switching your washing machine on, it
does not start immediately: it needs some
second in order to lock the door, fill water and
then drum starts turning.
• Spinning has an interrupted start-up: the drum
starts and stops running several times, to
improve spin efficiency and to better balance
the laundry.
• At the end of the spinning cycle the drum goes
on reversing for some minutes: this helps you
unloading the laundry.
• Do not exceed in detergents dosage: excessive
foam formation may prevent spinning.
• Your imbalance detection and correction
system reduces spin speed or interrupts the
spin automatically in case of imbalance load
- see “Troubleshooting guide”.
• Your machine has a new, electonically controlled motor: don’t be surprised by its
sound .
• If you want to change the programme during
the wash cycle, remember to switch the
machine off before turning the programme
selector knob.
5019 812 10015