Whirlpool , GGE388LXB, GGE388LXQ, GGE388LXS, GGE390LXQ Product Dimensions

Cabinet opening dimensions shown are for:
25" (63.5 cm) countertop depth,

24" (61 cm) base cabinet depth,
36" (91.4 cm) countertop height

®

30" (76 cm) Freestanding Electric Range

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

CABINET OPENING DIMENSIONS

GGE388LX GGE390LX

Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.

Electrical Connection:

●

This range is manufactured with the neutral terminal

connected to the cabinet. Use a 3-wire, UL listed, 40- or
50-amp power supply cord (pigtail) (see the following Range
Rating chart). If local codes do not permit ground through the
neutral, use a 4-wire power supply cord rated at 250 volts, 40
or 50 amps and investigated for use with ranges.

Ref. W10289536A

8/18/10

NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is
covered by not less than ¹⁄₄" (0.64 cm) flame retardant millboard covered
with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel,

0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance between the top of the cooking platform

and the bottom of an uncovered wood or metal cabinet.

Range Rating* Specified Rating of

Power Supply Cord Kit
and Circuit Protection

120/240 Volts 120/208 Volts Amps

8.8 - 16.5 KW 7.8 - 12.5 KW 40 or 50**

16.6 - 22.5 KW 12.6 - 18.5 KW 50

** The NEC calculated load is less than the total connected load

listed on the model/serial rating plate.

** If connecting to a 50-amp circuit, use a 50-amp rated cord

with kit. For 50-amp rated cord kits, use kits that specify use
with a nominal 1³⁄₈" (34.9 mm) diameter connection
opening.

●

A circuit breaker is recommended.

●

The range can be connected directly to the circuit breaker box
(or fused disconnect) through flexible or nonmetallic
sheathed, copper or aluminum cable. See the “Electrical
Connection - U.S.A Only” section.

B**

C*

A*

F

A. 35³⁄₄" ± ¹⁄₈" (90.8 cm ± 0.3 cm)

cooktop height (minimum) with
leveling legs screwed all the
way in*

B. Model/serial/rating plates

(located behind the control
panel)**

C. 47¹⁄₈" ± ¹⁄₈" (119.7 cm ± 0.3 cm)

overall height (minimum) with
leveling legs screwed all the
way in*

D. 28¹⁄₂" ± ¹⁄₄" (72.4 cm ± 0.6 cm)

depth with handle
E. 26¹⁄₈" ± ¹⁄₈" (66.4 cm ± 0.3 cm)***
F. 2 9¹⁵⁄₁₆" ± ¹⁄₁₆" (76.0 cm ± 0.2 cm)

width

D

E***

*Range can be raised approximately 1" (2.5 cm) by adjusting

the leveling legs.

**Model/serial/rating plates may be rotated up from behind the

control panel for viewing from the front of the range.

***Excludes handle. Dimension given is from wall to front of oven

door and will vary based on electric outlet receptacle
installation.

B

C

D

A

E

J

G

I

H

F

K

A. 18" (45.7 cm) upper cabinet

to countertop

B. 13" (33.0 cm) upper cabinet

depth

C. 30" (76.2 cm) min. opening

width.

D. For minimum clearance to the

top of the cooktop, see
NOTE.

E. 30" (76.2 cm) min. opening

width

Proper positioning of outlet shown above.

Nothing located in shaded areas can extend more than 1 " (3.8 cm)

from wall or range will not slide all the way back.

F. Cabinet door or hinge should

not extend into cutout*

G. 1 " (3.8 cm) min. from right

side cabinet

H. 2" (5.1 cm) min. from floor

I. 7" (17.8 cm) min. from floor

J. 8" (20.3 cm) width

K. 3 " (8.91 cm) min. from floor