INSTRUCTIONS FOR USE
INSTALLATION
ELECTRICAL CONNECTIONS
ENERGY SAVING TIPS
SAFEGUARDING THE ENVIRONMENT
PRECAUTIONS AND GENERAL ADVICE
CARE AND MAINTENANCE OF THE
GLASS-CERAMIC COOKTOP
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
To make the most of your new appliance, please read the user instructions carefully and keep
them to hand for future consultation.
4
INSTALLATION
Cooktop
• The cooktop must be set into a worktop 30 to 50 mm
thick
• There must be nothing between the cooktop and the
oven (cross rails, brackets, etc.).
• The distance between the lower face of the glass
ceramic hob and any cupboard or separating panel
must be at least 25 mm.
• If the cooktop is to be installed next to a column unit,
leave a distance of at least 100 mm from the edge of the
cooktop.
• Make an opening in the worktop of the dimensions shown in
the Product Description Sheet supplied separately.
• Apply the supplied gasket to the cooktop (unless it has
already been fitted), after having cleaned its surface.
Important
In order to prevent the electronic circuits from overheating, and
therefore from being damaged, we recommend the following:
• Do not install the cooktop near a dishwasher or
washing machine, so that the electronic circuits do
not come into contact with steam or moisture,
which could damage them.
• Make sure that the oven (manufactured by us) has a
cooling fan to protect electronic parts as much as
possible if the cooktop is installed above it.
If the temperature of the electronic circuits exceeds the
maximum permitted temperature, the cooktop will switch off
automatically; in this case, wait for a few minutes until the
internal temperature of the electronic circuits reaches a
tolerable level, at which point it will be possible to switch the
cooktop on again.
If a 900 mm cooktop is to be installed over a 600 mm oven
(which must be of our manufacture and equipped with a
cooling fan), a separator panel must be used in order to
prevent access to the lower face of the cooktop.
• Do not forget to switch the cooktop off. Should you
inadvertently forget to switch it off, the cooktop is
provided with an automatic switch-off feature after
1 to 6 hours of operation, depending on the
cooking level selected.
Assembly
The glass ceramic hob is designed to be fitted into a worktop.
1. Position the gasket around the entire perimeter of the
cooktop.
2. To secure the appliance in the worktop, use the springs
provided, screwing them into place, taking into account
the thickness of the worktop, as shown in the figure.
5
ELECTRICAL CONNECTIONS
Electrical connection must be made before connecting the
appliance to the electricity supply. The appliance must be
installed by a qualified technician who is fully aware of current
safety and installation regulations. Specifically, installation must
be carried out in compliance with the regulations of the local
electricity supply company. Make sure that the voltage indicated
on the rating plate corresponds to the voltage in your home.
Regulations require that the appliance is earthed: use conductors
(including the earth conductor) of the appropriate size only.
The manufacturer declines all liability for injury to persons or
animals and for damage to property resulting from failure to
observe the above regulations. For the electrical connection
use a H05 RR-F or H05V2V2- F type cable, as indicated in
the table below:
Power supply voltage
Conductors Amount x size
220-240 V ~
~ 3 X 2.5 mm
220-240 V 3 + ~ ~ 4 X 2.5 mm
400 V 3N + ~ ~ 5 X 2.5 mm
400 V 2N + ~ ~ 4 X 2.5 mm
2
2
2
2
If the cooktop comes already supplied with a power
supply cable, see the diagram for connection to the
mains electricity supply.
The appliance must be connected to the electricity
supply by means of an all-pole disconnect switch with
minimum contact gap of 3 mm.
Attention: the power supply cable must be long enough to allow
the cooktop to be removed from the worktop and must be
positioned so as to avoid damage or overheating caused by
contact with the base.
Connecting to the terminal board
Note: the yellow/green earth wire must be connected to the
terminal with the symbol and must be longer than the other
wires.
• Strip approx. 70 mm of sheath from the power supply
cable (B).
• Strip approx. 10 mm of sheath from the wires. First insert
the cable through the opening in the cover. Then insert the
power supply cable into the cable clamp and connect the
wires to the terminal board as indicated in the diagram printed
on the bottom of the protective cover of the cooktop.
• Secure the power supply cable (B) by means of the cable
clamp.
• Fit and secure the protective cover (A) which is screwed to
the lower face of the cooktop.
• After the electrical connection, fit the cooktop from the top
and hook it to the support springs, following the diagram.
6
ENERGY SAVING TIPS
• Use pots and pans whose bottom diameter is equal to that of
the cooking zone or slightly larger.
• Only use flat-bottomed pots and pans.
• If possible, keep pot lids on when cooking.
• Cook vegetables, potatoes, etc. with little water in order to
cut down cooking time.
• A pressure cooker allows you to save even more energy and
time.
SAFEGUARDING THE ENVIRONMENT
NO!
1. Packaging
• The packaging material can be 100% recycled,
as confirmed by the recycling symbol ( ).
2. Products
• This appliance is marked according to European
Directive 2002/96/EC (WEEE directive - Waste
Electrical and Electronic Equipment). By
ensuring this product is disposed of correctly
users can help prevent potential negative
consequences for the environment and health.
The symbol on the product or on the
documents accompanying the product
indicates that this appliance must not be treated
as household waste. Instead it must be
consigned to an authorised collection point for
recycling of electrical and electronic
equipment. Dispose of the appliance in
accordance with local environmental
regulations for waste disposal.
For more detailed information concerning the
treatment, recovery and recycling of this
product, please contact your local authority,
household waste disposal service or the shop
where you purchased the appliance.
Declaration of conformity CE
• This cooktop is suitable for contact with
foodstuffs and complies with EEC (CE)
Regulation n. 1935/2004.
• The appliances are designed solely for use as
cooking appliances. Any other use of the
appliances (e.g. for room heating) is to be
considered as improper and potentially
dangerous.
• The appliances are designed, built and sold in
compliance with:
• Safety objectives of the “Low Voltage”
Directive 2006/95/CE (which replaces
73/23/CEE and subsequent amendments).
• The protection requirements of Directive
89/336/EEC pertaining to “Electromagnetic
Compatibility”.
• The requirements of Directive 93/68/EEC.
7
PRECAUTIONS AND GENERAL ADVICE
• Before any maintenance on the appliance,
disconnect it from the electrical power supply.
• Keep children away from the appliances when
in use and when just switched off.
• Caution: Accessible parts of the appliance
can become very hot when the appliance
is operating. Keep children well clear of
the appliance to avoid the risk of burns.
This appliance must not be used by
children or infirm persons without
supervision. Ensure that children do
not play with the appliance.
This appliance is not intended for us by
persons (including children) with reduced
physical, sensory or mental capabilities or
lack of experience and knowledge unless
they have been given initial supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
• The appliances must be repaired or adjusted
exclusively by a qualified technician.
• Make sure that the electrical wires of other
electrical appliances near the cooktop do not
come into contact with hot parts.
• Do not switch on the hotplates/cooking zones
when there is no pan in position.
• The cooktop features different size hotplates/
cooking zones. Use pots whose base diameter
is the same as that of the hotplate/cooking
zone.
To avoid permanently damaging the
glass ceramic cooktop, do not use:
- pots with bottoms that are not perfectly
flat;
- metal pots with enamelled bottom
- When finished cooking, press button .
• Do not use the cooktop as a work surface or a
support surface.
• Do not leave the appliance unattended when
frying food - risk of fire.
• If the glass ceramic surface should break or
crack due to violent impact (falling objects, etc.)
do not use it and call the After-sales Service
immediately.
• Do not place food wrapped in aluminium foil,
plastic containers or cloths on the hot
cooking zones.
• Do not drag pans across the glass-ceramic
surface - risk of scratches.
• Avoid spilling sugar and similar substances on
the cooktop. If necessary, clean the cooktop
immediately following the care and
maintenance instructions in this handbook.
• If the cooktop is fitted with halogen lamps, do
not stare at them when they are switched on.
CARE AND MAINTENANCE OF THE
GLASS-CERAMIC COOKTOP
Never clean the appliance using steam cleaning equipment.
Clean the cooktop, when it is cool, after each use. This will
prevent the build-up of dirt and make cleaning easier.
• Use a clean cloth, absorbent kitchen wipes and washing up
liquid or a specific glass ceramic cleaner.
• Remove baked-on dirt with the supplied scraper tool and
specific cleaning products.
• Food spills should be cleaned off before they bake onto the
glass-ceramic surface.
• Foods with high sugar content (toffee, fruit juice, jam, etc.)
that boil over while cooking, or spattered sugar stains must
be immediately removed using a scraper.
• Do not use abrasive products, bleach, oven-cleaner spray or
pan scourers.
The cooktop should be treated periodically with a proprietary
brand of protective wax for glass-ceramic hobs.
8
TROUBLESHOOTING GUIDE
Cooktop not working
• When pressing the control buttons, did
you follow the instructions in the section
“Using the hob” in separate
“Product Description Sheet”?
• Is there perhaps a power failure?
• Did you dry the hob carefully after cleaning it?
AFTER SALES SERVICE
Before contacting After Sales Service
1. Try to solve the problem (see
“Troubleshooting Guide”).
2. Turn off the appliance and switch it back on
again to see if the fault persists.
If after the above checks the fault persists,
contact the nearest After-sales Service.
Please give: a short description of the fault,
• the precise type and model of the appliances,
• the service number (the number after the word
“Service” on the data plate), located under the
cooktop or on the Product Description Sheet.
The service number is also indicated on the
warranty booklet,
• your complete address and phone number.
In the event of a malfunction, the cooktop will
switch off automatically. The fault will be indicated
by means of a flashing letter “F” on the relative
display. At the same time, a warning buzzer
will sound for 3 seconds every 30 seconds.
The buzzer will switch off after 15 minutes.
Important!
If you are not able to turn the glass ceramic hob off
after using it, disconnect it immediately from the
power supply.
If any repairs are required, please contact an
authorized After-sales Service as indicated in the
warranty.
In the unlikely event that an operation or repair is
carried out by an unauthorised technician,
always request a certification of the job carried out
and insist on the use of original spare parts.
Failure to comply with these instructions may
compromise the safety and quality of the
product.
9
Loading...