Whirlpool LA7900XP User Manual
AUTOMATIC
WASHER
SuoSue; Capacity
LA7900XP
owave Ovens Trash Compactors Room Air Condllloners Oehumldlllers Aulomatlc Washers Clothes Oryers Freezers Refrlgeralor-Freeze
Parts and features
LOAD
SIZE
LAUNDRY
INFORMATION
, CENTER
TEMPERATURE
SELECTOR
/
MAGIC CLE/
LINT FILTE.
(not shown)
MODEL AND SERIAL
NUMBER PLATE
(not shown)
- LIQUID BLEACH
DISPENSER
- AGITATOR
-BASKET
-TUB
Remove the Consumer
Buy Guide label. It will be
easier to remove before
the washer is used.
You should wipe out the
basket with a damp cloth
before using to remove
dust from storing 0’
shipping.
-.~~~-
Copy your Model and Serial Numbers here
When you need service or call with a
question, have this information ready
1. Complete Model and Serial Numbers [from plate under the lid near the
hinge).
2 Purchase date from sales slip
Copy this information in these spaces.
Keep this book in the Laundry Information Center with your “Laundry Guide:’
sales slip and warranty.
L-
2
Model Number
Sew31 Number
P’Jrchase Date
Service Company
~~~ ___~~~~~
Phone
_-
Number
__-- ~-
!
Your responsibilities
Read this “Use and Care Guide”
and your “Laundry Guide” carefully for important use and safety
information.
u are personally responsible
,naking sure that your
washer...
l
is installed by a qualified installer.
l
is properly installed and
z
leveled on a floor that can
support the weight?
. is connected to the right kind
of outlet, electric supply, water
supply and drain.*
l
is properly grounded.*
l
is used only for jobs normally
expected of home automatic
washers.
l
is properly maintained.
l
is protected from the weather
and kept where the tempera-
ture will not fall below freezing.
l
is not run by children or anyone
unable to operate it properly
*See the”Installation Instructions”
for complete information.
Contents
Page
PARTS AND FEATURES. 2
YOUR RESPONSIBILITIES 3
SAFETY FIRST 3
STARTING YOUR WASHER 4
WHAT HAPPENS IN EACH
YCLE.
, rHER OPERATlk
INSTRUCTIONS
10
For a Rinse and Spin 10
For a Drain and Spin 10
For a Soak and Pre-Wash 10
Liquid Bleach Dispenser 11
MAGIC CLEAN ” Lint Filter 11
CARING FOR YOUR
WASHER.
12
IF YOU NEED SERVICE OR
ASSISTANCE..
14
1. Before Calling for
Assrstance 14
2. If You Need Assistance 15
3. If You Need Service 15
4. If You Have a Problem 15
91986 Whirlpool Corporation
6
Starting your washer
1
Measure aFsd adU detergent
2 Place sorted load In washer
3 Start washer
Select a
1. LOAD SIZE
l
To change the setting on the LOAD
SIZE SELECTOR, turn the knob to RESET
l
Then turn the knob to point at a
setting that describes the srze of the
load you want to wash.
l
Set the knob anywhere on or between HAND WASHABLE [a few smdrl
items) and EX LARGE (a full load)
See your “Laundry Guide” for details
on load sizes.
2.
l
Select wash and rinse water temperatures by pushing a button.
* Thus drawing shows a warm wash
(top temperature] and cold rinse
(bottom temperature) selection.
Recommended wash temperatures
can be found in your “Laundry Gu’
LOAD SIZES AND WATER LE\ELS
For best cleaning results, the
load must be able to move freely
in the water. Too big a load or toe
little water can cause wear or
tearing of load items
0
Select WATER
TEMPERATURES
CAUTION:
DO NOT
OVERLOAD WASHER.
*Approximate
fill with load.
EX-LARGE (20.5 gals 77.6 L)’
MEDIUM (13 9 gals. 52.6 L)’
HAND WASHABLE (78 gals 295 L)’
3. Start the washer
A.
Push in the Control Knob and
turn it to the right. It must be
pushed in and turned only
clockwlse
C.
Start the washer by pulling out
the Control Knob. The washer
will fill to the level you set with
wash water of the selected
temperature. After filling, the
washer will agitate for the
selected number of minutes
B.
Stop on a number in the cycle
you want. The numbers are minutes of wash time. The drawing
shows10 minutes of agitation in
the REGULAR Cycle.
D.
To stop the washer at any time
push in the Control Knob. To
restart the washer, pull out the
Control Knob.
--
5
Loading...