Whirlpool KRSF 9005/SL, KRSF 9005/BL INSTALLATION

KRSM 9005/A+

KRSC 9005/A+

Assembly instructions

Before installing the refrigerator 4

Water connection 4

Electrical connection 5

Positioning and levelling your refrigerator 6

Removing the freezer door (A) 7

Removing the refrigerator door (B) 7

Fitting the freezer door (C) 8

Fitting the refrigerator door (D) 8

Horizontal alignment of freezer and refrigerator door (E) 9

Vertical alignment of freezer and refrigerator door (F) 9

4

Your new appliance is a FULL NO FROST model exclusively for domestic use, i.e. both refrigerator and
freezer compartments are provided with an automatic defrosting function.
This manual contains indications and warnings for correct and safe installation of the appliance - read it
carefully before starting installation operations.
The model you have purchased may differ slightly with respect to some descriptions in this manual, since
this manual covers several models.
Keep this manual for future consultation. If you sell the appliance give it to the new buyer.
Install the appliance in a dry and well-ventilated place.
Avoid locations in direct sunlight or near a source of heat (oven, heating, etc.). If this cannot be avoided,
install the appliance respecting the following minimum distances:

Coal or paraffin stoves: 30 cm

Electric and/or gas stoves: 3 cm
To allow product handling and sufficient air circulation, leave at least 1 cm clearance at the sides, above the
appliance, and between the rear panel and the wall.

Before installing the refrigerator

Disconnect the appliance from the mains
power supply before starting operations.

• The ice maker and water circuit must be

connected to a water supply of potable drinking

water and/or chemically purified water.

• Make sure to comply with the current local

regulations regarding connection to the water

system.

• The appliance is supplied with a water pipe

(1.800 m. long) already connected to the back

of the product.

• The water pipe is in accordance with IEC 61770

standard.

• Remove the packing tape from the grey coiled

water pipe on the back of the product.

• Connect the transition connector (1) to the

household water supply (2).

• Make sure the water pipe is not twisted.

• The appliance is pre-set for operation at

pressures between 0.17 and 0.81 Mpa (1.7 and

8.1 bar).

• Open the water tap. Check for and eliminate

any leaks.

• The appliance does not require any adjustment

or water drain.

Water connection