Before using the dishwasher, read the user
instructions!
On button
Off button
Programme selection button
The selected programme is shown in the window
of the display.
Start button
Switches “on” when the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Reset button
After pressing the Reset button, the selected
programme and the supplementary functions
are cancelled (except the detergent and water
hardness settings, see user instructions) and must
be reset. On releasing the button this is confirmed
by an acoustic signal.
Indicators
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately before
starting a wash programme.
Options 3)
Time and failure display
Indicates in hours the time remaining until the start
of the wash cycle. Toward the end of the
programme, during the drying cycle, the display
will indicate the time remaining in minutes.
“F....” Identification of faults for service
technician
“Delayed start” button
The wash cycle can be programmed to start after 1
- 24 hours. With each successive touch of the
button, the delayed start indicator increases by 1
hour, and after 24 returns to 00. Then press the
Start button. The dishwasher will start at the set
time.
“Half load - Multizone” button
Load the upper or lower rack only.
This function can be used with any programme.
Press once = upper rack (the indication
lamp/symbol comes on)
Press twice = lower rack (the indication
lamp/symbol comes on)
Press 3 times = Off (half load function
deactivated).
When washing without the top rack, press the
“Half Load” button twice, or “Lower rack wash”
(the corresponding LED/symbol comes on).
Set detergent
(when the appliance is used for the first time and
when using a different type of detergent)
Off indicator = detergent (powder, gel, tablets)
Left indicator =2 in 1 detergent
Right indicator = 3 in 1 / 4 in 1 detergent
Turbo clean 7)
A higher spray pressure offers better cleaning, in
particular with very dirty dishes.
Quick Reference Guide
3