Whirlpool INDIANA 1200 INSTRUCTION FOR USE

Whirlpool is a registered trademark of Whirlpool USA
1)
1)
Spin
rpm
Speed
spin
Var iab le
1200
1000
1000
1200
1200
1)
1000
2)
1200
400
1200
1)
1000
and Start delay indicators
E. Programme selector
F. “Start/Pause” button
G. Spin speed selector
H. Programme sequence indicator
B
A
I
I. “Reset” button
J. “Start delay” button
G
Detergents and additives Special options Max
Max
Load
F
Rinse
Eco Intensive
Pre-
Softener Start
Main
Pre-
hold
rinse
wash
delay
wash
wash
❉❉
❉❉
❉❉
❉❉
5019 301 10328
❉❉❉
——
❉❉❉
Ye s
1.5
——
❉❉
3.0 Yes
was
Voor-
Start
selectie
❉❉❉❉❉❉❉
Ye s
kg
5.0
❉❉❉❉❉❉❉
Ye s
2.5
——
❉❉
3.0 Yes
—— —
❉❉
1.0 Yes
❉❉❉
—— —
——
—— — —
❉❉
❉❉
1.0 Yes
5.0
5.0
—— — —
1.0
—— — — ——— — — — —
C
D
H
E
J
Type of wash/Notes
- For temperature selection, respect the manufacturer’s recommendations
on the care label
Normally to heavily soiled bed linen, table linen and underwear, towels,
shirts etc. made of cotton and linen.
With heavily soiled laundry the additional “Prewash” option can be selected
as well.
Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen,
Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Curtains and delicate clothing, dresses skirts, shirts and blouses.
Care
Programme
Slightly to normally soiled textiles made of cotton and/or synthetics.
Labels
30 - 40 °C
Fijne was
Synthetisch
40 - 60 - 95 °C
Kookwas / Bonte was
30 - 40 - 60 °C
40 °C
Gemengde was
Only woollens with a felt-free finish, labelled with the woolmark and
identified as machine washable.
Shortly worn outer clothing made of cotton, polyester, polyamide and
blends with cotton.
30 °C
Snelwas
If you select “Rinse Hold” do not leave items to soak for too long.
Wol
Koud - 40 °C
Textiles made of linen, silk, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. A very gentle
spin is used in this programme.
30 - 40 °C
Handwas
Same as the last rinse and the final spin in the “Cotton” programme.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton”
programme.
In this programme spinning is gentle. Same as the spin cycle in the “Wool”
programme.
Drain only - no spinning. Alternative method of terminating programme after
“Rinse Hold”.
A. “Door open” indication
This washing machine is equipped with
automatic safety functions which
detect and diagnose faults at an early
GB INDIANA 1200 PROGRAMME CHART
stage and react appropriately, e.g.:
B. “Service” indication
C. “Water tap closed” indication
D. “Clean pump” indication
Cotton
40 - 60 - 95 °C
Rinse & Spin Spoelen & Centrifugeren
Spin Centrifugeren
Short Spin Kort Centrifugeren
Drain Afpompen
For improved garment care, spin speed is restricted to 1000 rpm in this programme.2) For improved garment care, spin speed is restricted to 400 rpm in this programme.
: optional / Yes : dosing required
1)
40 °C
30 - 40 °C
Delicates
Synthetics
30 - 40 - 60 °C
Daily load
30 °C
Quick wash
Woo l
Cold - 40 °C
30 - 40 °C
Handwash
Whirlpool is a registered trademark of Whirlpool USA
button to pause the
button again. The new
button for at least 3
5019 301 10328
RED INDICATIONS
“Service”
Lighting up of the “Service” indication can be caused by
a fault in an electrical component. Refer to the
“Troubleshooting Guide” in your Instructions for Use; if
the fault persists, contact our After Sales Service.
“Water tap closed”
The appliance has no or insufficient water supply.
START DELAY
The “Start Delay” allows to run the machine at the
consumer’s convenience, for example at night when
electricity is cheaper.
• Select programme, temperature and options.
time by 1, 3, 6, 9 or 12 hours.
• Press the “Start Delay” button to select the delay
*
Open the water tap; if the indication still lights up,
refer to the “Troubleshooting Guide” in the
button.
“Start/Pause”
The indication next to the “Start Delay” button
• Press the
Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether the
drain hose is kinked or the filter must be cleaned; in
PROGRAMME END
the latter case refer to the Instructions for Use
(“Removing the Filter”).
button,
“Start/Pause”
button has been pressed,
“Start/Pause”
lights up and goes off when the programme starts.
the countdown of the time delay begins. When
the programme starts, the start delay indicator
light goes off and is replaced by the programme
• Once having pressed the
sequence indication.
• After the
“Start/Pause”
indicator are off, and the “Door open”
indication lights up.
position.
• All the lights of the programme sequence
1. Turn the programme selector to the “Off/O”
2. Close the water tap.
3. Open the door and unload the machine.
CHANGE PROGRAMME AND/OR OPTIONS
4. Leave the door ajar to allow the drum to dry.
programme. The light flashes.
AFTER PROGRAMME START
1. Press the
2. Select the new programme (with temperature),
“Start/Pause”
any options and another spin speed if you want.
3. Press the
programme continues at the same position
where the previous programme was interrupted.
Do not add detergent for this programme.
CANCEL (RESET) A RUNNING
PROGRAMME BEFORE THE END
button cancels a programme before
“Reset”
The
the end.
“Reset”
seconds. Any existing water is drained out
before the door can be opened.
•Press the
button.
button.
“Start/Pause”
“Start/Pause”
“Reset”
the number of hours preselected can be reduced
by pressing again the “Start Delay” button.
To cancel the “Start Delay”
..before you press the “Start/Pause” button:
position or press the
• Turn the programme selector to another
the start delay indicator light goes out.
..after having pressed the “Start/Pause” button:
• Press the “Reset” button for at least 3 seconds -
PROGRAMME START
Open the tap and press the
The indication lamp next to the
button lights up. The programme sequence indicator
shows the current programme phase, running from
left to right through Wash, Rinse, Spin/Drain.
“DOOR OPEN” INDICATION
When the programme phase is finished, the
corresponding indication goes out.
Before starting and after end of a programme, the
lamp lights to show that the door can be opened. As
long as a wash programme is running, the door
remains locked and must on no account be forced
open. In case you have an urgent need to open it
during a running programme, refer to “Cancel
(Reset) a running programme before the end”.
button.
Duration
(hours : minutes)
Approx. Programme
1.90 2:00
(kWh)
Energy
*
(l)
Water
(kg)
Load
(°C)
Te m p e r a t u r e
0.70 1:30
• It is particularly useful if you want to postpone
spinning to a later time, or if you want to drain only.
The programme stops to “Rinse hold” at
Note:
**
without progressing to the final spin cycle to avoid
“Rinse hold” button
• The laundry remains in the last rinse water
creasing and prevent colours from changing.
programmes “Synthetics”, “Daily load” and
“Delicates”.
• This option is particularly recommended for the
60 5.0 49 0.95 2:20
button flashes.
button flashes.
“Start/Pause”
the time the “Anticrease” light in the programme
sequence indication is on. The indication lamp
next to the
Terminate the “Rinse hold” option:
button; the
“Start/Pause”
programme will terminate automatically with the
• Press the
final spin cycle for the present wash programme.
• If you do not wish to spin the clothes, turn the
“Start/Pause”
programme selector knob to the “Drain”
programme and press the
“Variable spin” button
•Every programme has a predefined spin speed.
• Press the button to set another spin speed.
cancelled but intermediate spin peaks remain
during rinse. The water is drained out only.
• If spin speed “0” is selected, the final spinning is
***
“Start/Pause”
Cotton 95 5.0 49
Programme
Cotton 40 5.0 49 0.60 2:00
Cotton 60 5.0 49 1.05 2:10
Delicates 30 1.5 50 0.50 0:45
Synthetics 60 2.5 50
Synthetics 40 2.5 45 0.55 1:15
Cotton with “Eco”
CONSUMPTION DATA
Wool 40 1.0 55 0.60 0:45
Daily load 40 3.0 45 0.45 1:00
Handwash 40 1.0 45 0.60 0:40
Quick wash 30 3.0 40 0.40 0:30
Handwash 30 1.0 45 0.50 0:40
The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions
applicable at that time.**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
Reference Programme for Energy Label.
ADD DETERGENTS, CLOSE THE DOOR
may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
*
Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home
AND SELECT THE PROGRAMME
***
Add detergent as indicated on the front page and as
described in the chapter “Detergent and Additives”
in your Instructions for Use.
Close the door and turn the programme selector to the
SELECT ANY DESIRED OPTION
desired programme and temperature. The indication
lamp next to the
Push the button(s) of any option(s) desired - the
respective indication lights up.
When the combination of programme and additional
option(s) is not possible, the indication lights switch
off automatically. Unsuitable combinations of
options are deselected automatically.
granular dirt) sensible. Increases the cycle time
by approximately 15 min.
prolonged washing duration, the optimum
combination of excellent washing result and even
• Only for heavily soiled loads (for example sand,
“Eco” button
• With a modified temperature profile and a slightly
“Prewash” button
lower energy consumption is achieved.
“Intensive rinse” button
• More water is added and rinse cycle is prolonged.
very soft water, washing baby linen and helps
people with allergies.
• This option is particularly suitable for areas with
Loading...