Whirlpool ICE2, F2WC9I1, P6GEG2KL, P6KG2KL, P6WG2KL Performance Data Sheet

PERFORMANCE DATA SHEET

Ice Maker Water Filtration System

Model ICE2, F2WC9I1, P6GEG2KL, P6KG2KL, P6WG2KL Capacity 2000 Gallons (7571 Liters)

System tested and certied by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor.

This system has been tested according to NSF/ANSI Standards 42 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specied in NSF/ANSI Standards 42.

Substance Reduction Aesthetic Effects

Chlorine Taste/Odor 50% reduction 1.9727 mg/L 2.0 mg/L ± 10% 0.71 mg/L 0.7788 mg/L 70.2 72.81

Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.50 gpm (1.89 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 2000 gallons (7571 liters).

■ It is essential that operational, maintenance, and lter

replacement requirements be carried out for the product to perform as advertised.

■ Use replacement lter P6RFWG2K, P6RFGEG2K,

P6RFKG2K, Part Number ICE2. Style 1 – When the water lter status display changes from “GOOD” to “ORDER,” order a new lter. When the lter indicator reads “REPLACE,” it is recommended that you replace the lter. Style 2 – Press FILTER to check the status of your water lter. If the lter indicator light is yellow and the words “ORDER FILTER” appear on the display screen, order a new lter. If the lter indicator light is red, it is recommended that you replace the lter.

■ These contaminants are not necessarily in your water supply.

While testing was performed under standard laboratory conditions, actual performance may vary.

■ The product is for cold water use only.

■ Do not use with water that is microbiologically unsafe or of

unknown quality without adequate disinfection before or after the system.

NSF Reduction Requirements

Average Inuent

Inuent Challenge Concentration

■ Refer to the “Warranty” section for the Manufacturer’s name,

address and telephone number.

■ Refer to the “Warranty” section for the Manufacturer’s limited

warranty.

Water Supply Potable City or Well

Water Pressure 30 - 120 psi (207 - 827 kPa)

Water Temperature 33° - 100°F (0.6° - 37.8° C)

Service Flow Rate 0.50 gpm (1.89 Lpm.) @ 60 psi

■ Your water ltration system will withstand up to 120 pounds

per square inch (psi) water pressure. If your water supply is higher than 80 psi, install a pressure reducing valve before installing the water ltration system.

Maximum Efuent

Application Guidelines/Water Supply Parameters

Average Efuent

Minimum % Reduction

Average % Reduction

NSF is a registered trademark of NSF International.

W11407771A