®
30" Slide-in Electric Range
PRODUCT MODEL NUMBERS
GY397LXU
GY399LXU
Electrical: This range is manufactured with the neutral terminal connected to the cabinet. Use a 3- wire, UL listed, 40or 50-amp power supply cord (pigtail) (see Range Rating chart below). If local codes do not permit ground through the neutral, use a 4-wire power supply cord rated at 250 volts, 40or 50-amps and investigaed for use with ranges. A time-delay fuse or circuit breaker is recommended. The model/serial rating plate is located on the oven frame behind the storage drawer panel.
Range Rating |
|
Specified Rating |
|
|
of Power Supply |
|
|
Cord Kit and |
|
|
Circuit |
|
|
Protection |
120/240 Volts |
120/208 Volts |
Amps |
|
|
|
8.8 - 16.5 KW |
7.8 - 12.5 KW |
40 or 50 |
16.6 - 22.5 KW |
12.6 - 18.5 KW |
50 |
OVERALL DIMENSIONS
30-3/4" (78.1 cm) cooktop width
35-3/4" (90.8 cm) |
|
cooktop height |
|
23-3/4" |
|
with leveling |
(60.3 cm) |
legs screwed all |
|
|
the way in
1" (2.5 cm) spacer
28-5/16"
(71.9 cm) depth with handle
29-7/8" (75.9 cm) width*
*30-3/4" (78.1 cm) with side panels
COUNTERTOP PREPERATION |
|
CABINET OPENING DIMENSIONS |
The cooktop sides of the slide-in range fit over the cutout edge of your countertop.
If you have a square finish (flat) countertop and the opening width is 30" (76.2 cm), no countertop preparation is required.
Formed front-edged countertops: Must have molded edge shaved flat 3/8" (1.0 cm) from each front corner of opening.
Cabinet opening dimensions shown are for:
25" (63.5 cm) countertop depth, 24" (61.0 cm) base cabinet depth, 36" (91.4 cm) countertop height
13" (33.0 cm) max. upper cabinet depth
30" (76.2 cm) min. cabinet opening width
For minimum clearance to the top of the cooktop, see NOTE.*
Tile countertops may need trim cut back 3/8" (1.0 cm) from each front corner and/or rounded edge flattened.
If countertop opening width is greater than
30" (76.2 cm), adjust the 3/8" (1.0 cm) dimension.
Countertop must be level. Place level on countertop, first side to side; then front to back. If countertop is not level, range will not be level. Oven must be level for satisfactory baking conditions.
30" |
3/8" |
|
(76.2 cm) |
||
(1.0 cm) |
||
opening |
||
|
||
width |
|
Formed or tiled countertop
30-3/4" (78.1 cm) trimmed 1/2" (1.3 cm) back at front corners of
countertop opening.
23-1/4" (59.1 cm) opening depth
3/8" (9.5 cm) radius both
corners
30" (76.2 cm) opening width**
junction box – 5.5" (14 cm min.) from either cabinet, 10" (25.4 cm) max. from floor.
Cabinet door or hinge should not extend into cutout.
*NOTE: 24" (61 cm) min. when bottom of wood or metal cabinet is protected by not less than 1/4" (6.4 mm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. 30" (76.2 cm) min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.
**30-7/8" (78.4 cm) with side panels.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation |
Ref. 8101P750-60 |
Instructions packed with product. Specifications subject to change without notice. |
04-09-08 |