Whirlpool GW395LEGT4, GW395LEGQ3, GW395LEGQ4, GW395LEGT3, GW395LEGQ0 Installation Guide

lati [ °

Gas Range

Quick Reference

Table of Contents:

Pages

[] Before you start
[] Product dimensions
[] Countertop preparatuon
[] Cabinet dimensions/requkements
[] Gas supply requirements
[] E[ectr[ca requirements

[_-[_ Installation steps

[] If range does not operate
[] If you need assistance service
[] Moving the range

If you need assistance:

Check your Use and Care Guide for a toil-free number to
ca[[ or ca[[ the dealer from whom you purchased this

appliance,The dealer is listed in theYe[[ow Pages of your

phone directory under "Appliances Household
Major Service and Repair"

Ca[[ when ,/ou:

Have questions about range installation or operation.
Need to obtain the name and number of an authorized
service company.

When you ca[[,you w[[[ need:

The range mode[ number.
The range serial number,

Both numbers are listed on the model/serial rating plate
located on the oven frame behind the storage drawer
panel

Tip Over Hazard

A child or adult can tip the range
and be killed.

Connect anti-tip bracket to rear
range foot.

Reconnect the ant{-tip bracket, if

the range is moved.

Failure to follow these instructions
can result in death or serious

burns to children and adults.

Pa_ No. 9753052 Rev.B

Before youstart,,,

Your safety and the safety of

others are very important,

We have provided many important
safety messages in this manual and
on your appliance. Always read and
obey all safety messages.

This is the safety alert
symbol.

This symbol alerts you to
potential hazards that can kill or hurt
you and others.

All safety messages will follow the
safety alert symbol and either the

word "DANGER" or "WARNING".
These words mean:

You can be killed or seriously

injured if you don't immediately

foltow instructions.

You can be kH_ed or seriously

injured if you don't follow

instructions.

All safety messages will tell you
what the potential hazard is, tell you
how to reduce the chance of injury,
and tell you what can happen if the

instructions are not followed.

IMPORTANT: Observe all governing
codes and ordinances.

Do not obstruct flow of combustion
and ventilation air.

in the State of Massachusetts, the

following installation instructions
apply:

o Installations and repairs must be

performed by a qualified or
licensed contractor, plumber, or
gasfitter qualified or licensed by

the State of Massachusetts.

° if using a ball valve, it shall be a

T-handle type.

° A flexible gas connector, when

used, must not exceed 3 feet.

WARNING: ff the
information in this manual

is not followed exactly, a
fire or expRos[on may result

causing property damage,
persona_ injury or death.

m Do not store or use

gasoline or other

flammable vapors and

liquids in the vicinity of

this or any other

appliance.
WHAT TO DO _FYOU
SMELL GAS

o Do not try to light any

appliance.

o Do not touch any

eRectrica[ switch.

o Do not use any phone in

your buimding.

o _mmediate[y call your

gas supplier from a
neighbor's phone. Follow

the gas supp[ier's

instructions.

off you cannot reach your

gas supplier, call the fire
department.

_nstam_ation and service

must be performed by a
qualified installer, service
agency or the gas

supplier.

The floor-mounted
anti-tip bracket must

be installed.To install

the anti-tip bracket

shipped with the
range, see Page 7 and

the anti-tip bracket template/instruction

sheet,

This installation must conform with
all local codes and ordinances, in the
absence of local codes, installation

must conform with American
National Standard, National Fuel Gas

Code ANSI Z223.1 -- latest edition _-
or CAN/CGA--B149 -- latest edition _

installation codes.
it is the customer's responsibility:

oTo contact a qualified electrical

installer.

*To assure that the electrical
installation is adequate and in

conformance with National Electrical

Code, ANSI/NFPA 70 - latest
edition __, or CSA Standard C22.1,
Canadian Electrical Code, Part 1 -

latest edition _, and all local codes
and ordinances.

Cabinet opening dimensions shown
must be used. Given dimensions are

minimum clearances.

When installing a cooktop under

existing cabinets and the installation
does not meet the minimum cabinet

clearances, install a range hood
above the cooktop to avoid burn

hazards.
Proper installation is your

responsibility. A qualified technician
must install this range. Make sure

you have everything necessary for
correct installation, it is the installer's

responsibility to comply with
installation clearances specified on

the gas information label.The gas

information label and model/serial
rating plate are located on the oven
frame behind the storage drawer
panel.

Grounded electrical supply is
required. See "Electrical

requirements;' section.
Proper gas supply connection must

be available. See "Gas supply
requirements;' section.

Mobile home installation
The installation of this range must

conform to the Manufactured Home
Construction and Safety Standards,

Tide 24 CFR, Part 3280 (formerly the
Federal Standard for Mobile Home

Construction and Safety, Title 24,
HUD, Part 280); or when such

standard is not applicable, the
Standard for Manufactured Homes
installations (Manufactured Home

Sites, Communities and Setups),
ANSi A225.1/NFPA 501A _, or with
local codes.

in Canada, the installation of this
range must conform with the current

standards CAN/CSA-Z240- latest
edition _-,or with local codes.

When this range is installed in a

mobile home, it must be secured to

the floor during transit. Any method

of securing the range is adequate as
long as it conforms to the standards

listed above.

Copies of the standards listed may be
obtained from:

CSA Ir_terr_ational
8601 East Pbasant Valley Road

Cbveland, Ohio 44131-5575

_National Fire Protection Association

One Batterymarch Park
Quincy, Massachusetts, 02269

ievei
fiat-Made screwdriver

3/8" drive ratchet
3/8"' and 5/16"' nut driver

, hand or eHectrb drHi
,channei Hock pliers

safety giasses
gioves

measuring tape or ruier
wood floors: 1/8" drHi bit

concrete/ceramic floors: 3/16"' carbide-

tipped masonry drHi bit (Hammer may

be needed for anchors.}

30-3/4" (78.1 cm}
cooktop width

J

38" (91.4 cm)

cooktop height
with leveling

legs lowered
1-1/2 turns

22-1/2"

(57.1 cm}_

ftoopmounted

anti-tip bracket

Not shown:
literature pack

alastic anchors

(#10 x 1-1/2"}

Brackets must be securely mounted to
sub-floor.Thickness of flooring may require
longer screws to anchor bracket to sub-floor.
Longer screws are available from your local

hardware store,

The cooktop sides of the siide-in
range fit over the cutout edge of

your countertop.
if you have a square finish (fiat)

countertop and the opening width is
30-3/8" (77.2 cm), no countertop
preparation is required.

Formed front-edged countertops:
Must have moided edge shaved fiat

1/4" (0.64 cm} from each front corner

of opening.
TiMecountertops may need trim cut

back 1/4" (0.64 cm) from each front
corner and/or rounded edge

flattened.
if countertop opening width is

greater than 30-3/8" (77.2 cm), adjust

the 1/4" (0.64 cm) dimension.

Countertop must be ievei. Piace ievei
on countertop, first side to side; then

front to back. if countertop is not
ievei, range wili not be ievei. Oven

must be ievei for satisfactory baking
conditions.

30" (76.2 cm)

width

Formed or flied countertop trimmed 1/4"
(0.64 crn} back at front corners of countertop
opening.

Cooktop sides of range
fit over edges of
countertop opening.

f