Whirlpool GU120ESJQ INSTRUCTION FOR USE

GB

GU 120 ES

WASH CYCLE CHART

Further indications are given in the pages to follow and in the user instructions.

Start button

Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the cycle.

Cycle selector

Place the detergent in the:

small large

Cycle description Recommended load

Rinse / Pre-wash

Rapid 40° C

Normal 50° C

Heavy 65° C

Intensive 70° C

1) Your values may vary due to load composition, water inlet temperature, water hardness and power supply voltage.

2) Cycle recommended for use with traditional non-enzyme based detergents.

2)

Dishes to be washed later.

Rapid short wash for lightly soiled dishes.

Normally soiled dishes.

Normally or heavily soiled dishes.

Heavily soiled pots and pans.

compartment compartment

Consumption

Normal load

Water

(Litres)

--5.00.0210

- X 13.5 0.05 21

X X 18.5 0.96 96

X X 18.5 1.11 102

X X 22.5 1.28 106

Energy

(kWh)

1)

Time

(Min.)

5019 100 91298

(We reserve the right to make technical modifications)

C

C

How to use the dishwasher

1. After loading the dishwasher, cl ose the
door properly. Ensure that the water
supply is turned on.

2. The dishwasher switches on
automatically as soon as the cycle
selector knob is turned.

indicator lamps will switch on.

3. Turn the selector knob to select the
desired cycle.

indicator lamp lights up.

select options (if supplied).

4. Press the Start button to start the
selected cycle.

lamp will light up.

programmed data cannot be altered by
turning the cycle selector knob.

once the Start button has been

Note:

pressed, the dishwasher memorises the
last cycle selected. This information
remains in the memory even during
interruption of the power supply.

To change the cycle selected,
press the Start button and hold it
depressed for about 5 seconds.
The Start indicator lamp will
switch off. Select a new cycle
and press the Start button.

if the dishwasher is switched off

Note:

during a wash cycle, when switched
on again it will resume the wash cycle
from where it was interrupt.

Only open the dishwasher door if
strictly necessary during a wash
cycle and exercise maximum
caution. Escaping steam may be

5. To indicate the end of the cycle, the

extremely hot.

Start indicator lamp switches off and

the End indicator lamp (if fitted)

lights up

(for about 30 min.)

One of the cycle

The corresponding

If required,

The Start indicator

Once set, the

.

6. Once the start indicator lamp has
switched off, turn the cycle selector
knob to the zero position to switch off
the dishwasher.

indicator lights will switch off

7. Open the door slowly (beware of hot
steam). Unload the lower rack before
the upper one.

At this time, all the

.

Upper rack

Rack height adjustment:

(The dishwasher is delivered with the upper
rack in the top position).
The rack height can also be changed
when loaded.

Upper and lower rack

• To lower: pull out the
handles and gently lower the rack.

• To raise: pull up the
until the rack clicks into place.

• The rack must be level on both
sides.

Cup holders:

• Down: cups and long-stemmed
glasses.

•

Up: plates.

Glass holder:

two

side handles

two

side

Lower rack

Cutlery basket (C):

• With or without handle
(depending on model).

• The cutlery basket (C) can be
removed to increase available
space when necessary.

Please read the user instructions carefully.