GSF 5243 W-WS
GB
GSF 5243
Quick Reference Guide
Further indications are given in the pages to follow and in the user instructions.
Start button
Indicator lamp lit while the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
On / Off Button
Programme Symbol
and Temperature
Pre-wash
Rapid 40° C
Bio-Normal 50° C
Normal 65° C
1) Values may vary in relation to usage, e.g.: different loads, water
temperatures - above or below 15° C - as well as water hardness and power supply voltage.
2) Programme recommended when using detergents of type B (enzyme-based detergents).
Reference programme for energy label.
3) Programme recommended when using detergents of type A (non enzyme-based detergents).
Crockery to be washed later.
Lightly soiled crockery with no dried-on food.
2)
Normally or heavily soiled crockery with dried-on food.
3)
Normally or heavily soiled crockery with dried-on food.
Programme selection and
recommended load type
Place the detergent in the:
small large
compartment compartment
- - 5.0 0.02 9
- X 13.0 0.85 30
X X 16.0 1.40 86
X X 16.0 1.60 86
Water
(Litres)
Consumption
Normal load
Energy
(kWh)
5019 100 90301
(We reserve the right to make technical modifications)
1)
Time
(Min.)
C
How to use the dishwasher
1. After loading the dishwasher, cl ose the
door properly and open the water
supply tap.
2. Press the On/Off button to switch the
dishwasher on.
programme indicator lamps will
switch on.
3. Select the desired programme by
pressing the corresponding button.
The corresponding indicator lamp
lights up.
supplied).
4. Press the Start button to start the
selected programme.
indicator lamp will light up.
Once set, the programmed dat a cannot
be altered by pressing the programme
selector buttons.
once the Start button has been
Note:
pressed, the dishwasher memorises the
last programme selected. This
information remains in the memory even
during interruption of the power supply.
To change the selected
programme, press the Start button
for about 5 seconds,
indicator lamp switches off.
Select a new programme using the
programme selector knob and press
the Start button.
if the dishwasher is switched off
Note:
during a wash programme, when
switched on again it will resume the wash
cycle from where it was interrupted.
Only open the dishwasher door if
strictly necessary during a wash cycle
and exercise maximum caution.
Danger of scalding from steam.
5. To indicate the end of the programme,
the Start indicator lamp switches off
and
the End indicator lamp (if fitted)
lights up
One of the
If required, select options (if
The Start
until the Start
(for about 30 min.)
.
6. Once the Start indicator lamp has
switched off press the On/Off bu tton to
switch the dishwasher off.
indicator lamps switch off.
7. Open the door (warning: beware of hot
steam). Unload the lower rack before
the upper one. Close the water tap.
All the
Upper rack
Rack height adjustment:
(The dishwasher is delivered with the
upper rack in the top position).
The rack height can also be changed
when loaded.
• To lower: pull out the
handles and gently lower the rack.
two
side
Upper and lower rack
• To raise: pull up the
until the rack clicks into place.
• The rack must be level on both
sides.
Crockery holders:
• Down: cups and long-stemmed
glasses.
•
Up: plates.
Glass holder:
• The glass holder can be moved
sideways.
• Below: small glasses.
• Above: long-stemmed glasses.
side handles
two
Lower rack
Cutlery basket (C):
• With or without handle (depending
on model).
• The cutlery basket can be removed
to increase available space
.
Please read the user instructions carefully.
Loading...