Whirlpool GBS309PVS00, GJC3034RS04 Installation Guide

CUTOUTDIMENSIONSFOROVENSINSTALLEDUNDERCOOKTOP

IMPORTANT: Observe all governing codes and ordinances. Cooktop must be approved for use over an oven. See Cooktop Installation
Instructions for cutout dimensions. Center the cooktop cutout over oven cutout.

To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor,
delaminate or sustain other damage. This oven has been designed in accordance with UL and CSA International and complies with the
maximum allowable wood cabinet temperatures of 194°F (90°C).

C,

L....

D_

=

G

I

A. 24" (61 cm) cabinet depth

B.25" (63.5 cm) countertop depth
C. Recommended oven and cooktop junction box locations
D. Allow %" (!.6 cm) for oven to overlap each side.

E.273/4" (70.5 cm) minimum cutout height

F. 36" (91.4 cm) from cabinet base to countertop
G. 4%" (! 1.7 cm) from floor

H. See Cutout Dimensions chart.

CUTOUT DIMENSIONS
Oven Size
24" (61 cm)

27" (68.6 cm)
30" (76.2 cm)
36" (91.4 cm)

\

\

Oven Cutout Dimension
221/2'' (57.2 cm)

251/2'' (64.8 cm)
281/2'' (72.4 cm)

341/2'' (87.6 cm)

For the approved model number combinations refer to the undercounter label located on top of the oven chassis and on the
bottom of the cooktop burner box.

NOTE: For undercounter installation, it is recommended that the junction boxes for oven and cooktop be located in the adjacent right or

left cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall surface
to pass the appliance cable through to the junction box. On models with Steam-Assist, it will be necessary to drill a 1/2"(1.3 cm)
minimum diameter hole in the upper right or left rear corner of the side wall to pass the water supply tubing through to the undersink
water filter. If water supply tubing hole is drilled on the same side as the oven cable hole, a minimum of 2" (5.1 cm) is required between

the 2 holes.

8304571A

_ • _, •, _ _ , ;_'_, _ _ •,6 _ _ "'_ _ _

J

F

M

/

/

/

\

\

N

A.24" (61 cm)cabinet depth

B. 1" (2.5 cm) clearance from the top ofjunction box to bottom of

countertop.
C.25" (63.5 cm)countertop depth
D.Recommended ovenjunction box locations

E.1" (2.5 cm) clearance from the side of junction box to cabinet walL

E 273/4"(70.5cm) minimum cutout height
G.Allow %" (1.6cm) for oven to overlap each side.
H.36" (91.4 cm)from cabinet base to countertop

CUTOUT DIMENSIONS
Oven Size

24" (61 cm)
27" (68.6 cm)
30" (76.2 cm)
36" (91.4 cm)

Oven Cutout Dimension
22W' (57.2 cm)

25W' (64.8 cm)
28Vd' (72.4 cm)

34W' (87.6 cm)

I.Gas line through wall !OW' (26.7 cm) to center of cutout

J. 3V4" (8.3 ctT_)

K.Gas line through floor 101/2"(26.7cm) to center of cutout

L. 31/2 '' (8.9 cm)

M.4%" (11.7cm) from floor

N.See Cutout DimensionscharL

For the approved model number combination refer to the undercounter label located on top of the oven chassis.
NOTE: For undercounter installation, it is recommended that the junction box for oven be located in the adjacent right or left cabinet. A

1" (2.5 cm) minimum diameter hole should have been drilled in the upper rear right or left corner of the side wall surface to pass the
appliance cable through to the junction box.

On models with Steam-Assist, it will be necessary to drill a W' (1.3 cm) minimum diameter hole in the upper right or left rear corner of
the side wall to pass the water supply tubing through to the undersink water filter. If water supply tubing hole is drilled on the same side
as the oven cable hole, a minimum of 2" (5.1 cm) is required between the 2 holes.

The upper shaded areas are recommended locations for recessed junction box for 120-volt grounded outlet for cooktop.
Lower shaded areas are recommended locations for flexible or rigid gas pipe installation. The gas pipe can be installed on either side of

the cutout, and either through the floor or through the wall.