Whirlpool GI7FVCXW User Manual

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS
LOCATION REQUIREMENTS
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
Ref. W10226405-D-WH
06-12-09
D
overall
C
top of
cabinet
E
(including
handle)
Depth Closed Depth Closed
(incl. handle) (excl. handle) Cab. Height Overall Height Cab. Width
Model # "A" "B" "C" "D" "E"
GI7FVCXW 35
1
4
"32
7
8
"68
9
16
" 70" 35
5
8
"
(89.54 cm) (83.5 cm) (174.14 cm) (177.8 cm) (90.5 cm)
To ensure proper ventilation for your refrigerator, allow for a
1
2" (1.25 cm) space at the top and behind
the refrigerator. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. When installing your refrigerator next to a fixed wall, leave 3
3
4" (9.5 cm) minimum space
between the refrigerator and wall to allow the door to swing open.
NOTE: It is recommended that you do not install the refrigerator near an oven, radiator, or other heat source. Do not install the refrigerator in a location where the temperature will fall below 55°F (13°C).
Bottom Mount Refrigerator
A
®
B
GI7FVCXW
Electrical Requirements: A 115-volt, 60-Hz, AC-only, 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn Cooling OFF, and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and turn Cooling ON. See “Using the Controls.”
Water Supply Requirements: A cold water supply with water pressure of between 35 and 120 psi (241 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a licensed, qualified plumber.
If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa).
¹⁄₂" (1.25 cm)
3³⁄₄" (9.5 cm)
Loading...