4GB96012.fm Page 1 Wednesday, October 15, 2003 3:32 PM
Before using the dishwasher, read the user instructions!
GCIE 6584 |
Quick Reference Guide |
GB |
|
|
|
||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
“On/Off” button
Press the ON button to switch on the dishwasher.
The On/Off indicator lamp lights up and the display shows the last programme selected.
Retractable programme selector knob
Press and turn the knob to select the desired 
programme.
Once the programme has been selected, the display shows the programme reference
number (p1...p5).
Additional options
“Eco Dry” button
Press the button to active drying using the energy-saving ventilation system.
“Delayed Start” button
The wash cycle can be programmed to start after 1-12 hours. Then press the Start button. The dishwasher will start at the set time.
Start button
Press to start the wash cycle and keep pressed until an acoustic signal confirms the start of the wash cycle. The display shows the approximate duration of the wash cycle.
Display
The display shows all the information relating to the functions selected.
Indicators
Add rinse aid
Add regeneration salt
Only add regeneration salt immediately before starting a wash programme.
|
|
Programme chart |
Eco |
Detergent 2) |
Consumption 3) |
|||||
|
|
|
|
|
Dry |
|
|
|
|
|
|
|
Programmes |
|
Loading instructions |
|
A |
B |
Litres |
kWh |
Minutes |
|
|
|
|
|
|
|
|
|
|
|
P1 |
|
Pre-Rinse |
cold |
Crockery to be washed later. |
- |
- |
- |
5.0 |
0.02 |
9 |
|
|
|
|
|
|
|
|
|
|
|
P2 |
|
Delicate 4) |
45°C |
Lightly soiled crockery with no |
X |
X |
- |
12.0 |
0.90 |
79 |
|
|
|
|
dried-on food. |
|
|
|
|
|
|
P3 |
|
Normal 4) |
55°C |
Normally or heavily soiled |
X |
X |
- |
13.0 |
1.23 |
100 |
|
|
|
|
crockery. |
|
|
|
|
|
|
P4 |
|
Bio-Eco 1) 4) |
55°C |
Normally soiled crockery. |
X |
X |
- |
13.0 |
1.01 |
160 |
|
||||||||||
|
|
|
|
|
|
|
|
|
|
|
P5 |
|
Intensive 4) |
70°C |
Recommended programme for |
|
|
|
|
|
|
|
heavily soiled crockery, especially |
X |
X |
X |
20.0 |
1.48 |
125 |
|||
|
|
|
|
suitable for pans and saucepans. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1)Reference programme for energy label in compliance with EN 50242 regulations (the reference cycle refers to a cycle with the “Eco Dry” function selected);
2)Refer to “User instructions”;
3)Program data obtained in conformity with European standard EN 50242. Values may vary in relation to usage, e.g.: different loads, water temperatures - above or below 15°C - as well as water hardness and power supply voltage, etc.
4)Selecting the “Eco Dry” function increases the duration of programmes by 20 min.
5019 496 96012
(We reserve the right to make technical modifications)
Black process 45.0° 100.0 LPI
4GB96012.fm Page 2 Wednesday, October 15, 2003 3:32 PM
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Close the door
How to fill the detergent dispenser
Check the rinse aid level
Check the regeneration salt level
Load the racks
Select a programme
Select additional options
Press the Start button to start the programme
Press the On/Off button 
.
Large compartment A: |
|
|
C |
|
B |
A |
|
|
|
||
Small compartment B: |
|
|
|
|
|
|
|
Mechanical indicator C. |
|
|
|
Electric indicator on control panel (if provided). |
|
|
|
On models with water softener system only. |
D |
||
Mechanical indicator D. |
|
|
|
Electric indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
Press the knob 
and turn to select the programme.
If necessary (and if provided).
The corresponding indicator lamp lights up.
“Cancel”
Press the “Start” button and keep pressed until the number (P1, P2...) of the programme in progress appears on the display.
Press the “Start” and “Delayed start” buttons at the same time. The display shows “P-” and the programme is stopped.
“Change programme in progress”
Press the “Start” button and keep pressed until the number (P1, P2...) of the programme in progress appears on the display.
Select and start the programme as described previously.
Turn on the water tap, close the dishwasher door
Wash cycle
Switch off the appliance
Turn off the water tap, unload the racks
- Only open the dishwasher if necessary (Warning: beware of hot steam).
- If the appliance is switched off during a wash cycle, when switched on again it will resume the cycle from where it was interrupted.
Press the On/Off button to switch off the appliance. All the indicator lamps and the display switch off.
Warning: When the door is opened steam comes out!
Unload the appliance, starting from the lower rack.
Black process 45.0° 100.0 LPI
Loading...