Whirlpool FL 6045 INSTRUCTION FOR USE

GB FL 6045
Cotton Synthetic
Delicate/Wool
On/Off
Half Load
No Spin
PROGRAMME CHART
Estimated Programme Duration refer to maximum programme temperature selection without special options.
During the selected washing programme the programme selector knob moves by steps clockwise through the phases
rinse and spin
to several minutes.
: optional / Yes : dosing required
. Each step takes from some seconds
prewash, main wash
,
Programme
Selector
Knob
1 2 3 4 4 5 6
A B C D
E
Programme
Cotton
with prewash
Cotton
Synthetic
Cotton
short
Synthetic
short
Delicate
Wool
Rinse +
Long spin Long spin
Rinse +
Short spin Short spin
Drain
Tem pe ra tu re
°C
Min Max. 95°
Min Max. 95°
Min Max. 60°
Min Max. 40°
Min Max. 40°
Min Max. 40°
Min Max. 40°
Min
Min
— —
Type of wash/Notes
Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc.).
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Slightly soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. Slightly soiled overalls and sports wear made of cotton, polyester, polyamide and blends with
cotton. Curtains and delicate clothing, dresses skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine
washable.
With this programme you can add starch and/or fabric softener. The programme ends with an intensive spin cycle.
In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme. In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.
Drain only - no spinning. Alternative method of terminating programme the synthetic, delicate and wool programme and for premature removal of the laundry.
Max
Load
Kg
5.0
5.0 Yes
2.0 Yes
2.5 Yes
2.0 Yes
1.5 Yes
1.0 Yes
5.0
Detergents and additives Special options Max.
Pre-
wash
Main
Wash
Yes
Fabric
Softener
Chlorine
Bleach
Half
LoadNoSpin
❉❉❉❉
❉❉❉❉
——
——
❉❉
❉❉
❉❉
❉❉
Estimated
Spin
Programme
Speed
rpm
Duration
Min.
600 120
600 110
600 85
600 75
600 75
600 70
600 60
600 20
5.0 600 15
1.5
——
600 15
1.5 600 10 —— — — — — — 6
Whirlpool is a registered trademark of Whirlpool USA
5019 301 10273
CONSUMPTION DATA
Programme
Temperature
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Estimated Programme
Duration
Min.
Cotton with prewash 95 5.0 80 2.00 120
Cotton 95 5.0 70 1.80 110 Cotton 60 5.0 70 1.20 110
Synthetics 60 2.0 60 0.90 85
Cotton short 40 2.5 65 0.70 75
Synthetics short 40 2.5 60 0.60 75
Delicate 40 1.5 80 0.60 70
Wool 40 1.0 80 0.60 65
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the energy label refer to the programme Cotton 60°C.
ADD DETERGENTS, CLOSE THE DOOR AND
SELECT ANY DESIRED OPTION
SELECT THE PROGRAMME
Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in the booklet.
“Half Load” button
• Reduces water consumption, above all during rinsing. Suitable for lightly-soiled laundry and small loads (max 3 kg).
1. Open the tap.
2. Set the
programme selector
to the desired
programme.
3. Set the
temperature selector
to the desired
temperature.
4.
Special options
can be selected.
5. Check that the door is well closed and turn on the washing machine by pressing the
“ON/OFF”
“No Spin” button
• Excludes spinning from programme, press button. Suitable for delicate laundry .
with the “Cotton” and “Synthetic”
Note:
programmes a short spin cycle is provided in any case, even if the exclusion has been selected, in order to optimize rinsing results.
button. The indicator lights up, indicating that the washing machine is on.
PROGRAMME CHANGE
To reselect a programme when a cycle has already started:
1. Switch off the appliance by pressing the “
ON/OFF
” button.
2. Select the new programme, temperature and options.
3. Start the programme by pressing the “
ON/OFF
” button again.
PROGRAMME END
1. At the end of the programme the programme selector moves to the stop position.
2. To unload the washing machine wait for the door to unlock (about 2 minutes).
3. Switch off the washing machine, open the door and take out the laundry.
4. Close the tap and leave the door ajar to allow the drum to dry out.
NOTES AND INDICATIONS FOR USE
Water level
To obtain low water consumption without compromising washing results the water level within the drum may not be visible.
Cleaning the pump filter
A regular filter check and eventual cleaning is advisable.
Motor smell
Washing machine motor creates a typical electrical smell during first cycles, this is normal and disappears after a few cycles.
Whirlpool is a registered trademark of Whirlpool USA
5019 301 10273
Loading...