Whirlpool FL 5006, FL 5500, FL 5064/2, FL 5590, FL 5557 INSTRUCTION FOR USE
...
3gb10011.fm5 Page 2 Monday, June 18, 2001 1:08 PM
CONTENTS
BEFORE USING THE WASHING MACHINE
FIRST WASH CYCLE
PRECAUTIONS AND GENERAL RECOMMENDATIONS
DESCRIPTION OF THE WASHING MACHINE
PREPARATION OF THE WASHING
DETERGENTS AND ADDITIVES
LIQUID BLEACH (HYPOCHLORITE)
DYEING
WASHING PROGRAMME
REMOVING THE FILTER
DRAINING RESIDUAL WATER
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
TRANSPORT AND HANDLING
INSTALLATION
Black Process Plate
3gb10011.fm5 Page 3 Monday, June 18, 2001 1:08 PM
BEFORE USING THE WASHING MACHINE
1.Removing the packaging and check
•
After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use
the washing machine. Contact After-Sales
Service or your local retailer.
•
Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
2.Remove the transit bolts
•
The appliance is fitted with transit bolts to
prevent internal damage during transport.
Before using the washing machine you must
remove the transit bolts
Remove the transit bolts”).
(see “Installation/
3.Install the washing machine
•
Move the machine without carrying it at the top.
•
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
•
Adjust the feet to ensure that the machine is
stable and level (see “Installation / Adjust the
feet”).
4.Water supply
•
Connect the water supply inlet hose in
accordance with regulations of your local water
company (see “Installation/Connect the water
inlet hose”).
•
Water supply: cold water only
•
Tap: 3/4” threaded hose connection
•
Pressure: 100-1000 kPa (1-10 bar).
5.Drain hose
•
Connect the drain hose to the siphon or hook it
over the edge of a sink by means of the “U” bend
(see “Installation/Connect the water drain hose”).
•
If the washing machine is connected to a built-in
drainage system, ensure the latter is equipped with
a vent to avoid simultaneous loading and draining
of water (siphoning effect)
6.Electrical connections
•
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and current standard
safety regulations.
•
Voltage information, power consumption and
electrical protection data are supplied on the
inside of the appliance door.
•
The appliance must be connected to the mains
exclusively by means of a socket with an earth
connection in accordance with established
regulations. The appliance must be earthed by
law. The manufacturer declines all liability for
damage to property or injury to persons or
animals deriving either directly or indirectly
from failure to observe the directions.
•
Do not use extension leads or multi sockets.
•
Before any maintenance on the washing
machine disconnect it from the mains supply.
•
Access to the mains plug or to disconnection
from mains supply via a double-pole switch must
be ensured at all times following the
installation.
•
Do not operate the washing machine if it has
been damaged during transport. Inform the
After-Sales Service.
•
Mains cable replacement is only to be carried out
by After-Sales Service.
•
The washing machine must only be used in the
household for the prescribed uses.
Minimum housing dimensions:
Width: 600 mm
Height: 850 mm
Depth: 600 mm
Black Process Plate
3
3gb10011.fm5 Page 4 Monday, June 18, 2001 1:08 PM
FIRST WASH CYCLE
We recommend the first wash cycle be made without laundry.
This will remove any residual water used in testing your washing machine.
1.
Turn on the tap.
2.
Close the appliance door.
3.
Pour a small amount of detergent (about 30 ml) into the detergent dispenser .
4.
Select a short program (see programme chart).
5.
Press the
“On/Off”
button.
PRECAUTIONS AND GENERAL RECOMMENDATIONS
1.Packing
•
The packing box may be fully recycled as confirmed
by the recycling symbol. Adhere to local
regulations when disposing of packaging material.
2.Energy saving tips
•
Achieve the best use of energy, water, detergent and
time by using the recommended maximum load size.
•
Do not exceed the detergent dosages indicated
in the manufacturer’s instructions.
•
The Eco Ball - a special system in the outlet - will
prevent detergent loss from the drum to avoid
detergent loss into the environment (depending
on the model).
•
Use “Prewash” for heavily soiled laundry only!
Save detergent, time, water and energy
consumption by not selecting “Prewash” for
slight to normally soiled laundry.
•
Pretreat stains with stain remover or soak dried
in stains in water before washing to reduce the
necessity of a hot wash program.
•
Save energy by using a 60° C instead of a 90° C
wash programme or a 40° C instead of a 60° C
wash programme.
•
Save energy and time by selecting a high spin
speed to reduce the water content in laundry
before using a tumble dryer (for machines with
adjustable spin speed).
3.Disposing of packaging and old appliances
•
The washing machine is built from reusable
materials. The washing machine must be disposed of
in compliance with local waste disposal regulations.
•
Before scrapping of your old machine, cut off the
power cable so that it cannot be connected to
the mains.
•
Remove detergent from compartment if you
intend scrapping your appliance.
4.Child safety
•
Children must not be allowed to play with the
washing machine.
5.General recommendations
•
When the appliance is not in use unplug it and
turn off the tap.
•
Before cleaning or carrying out maintenance,
switch off the washing machine and disconnect
it from the mains supply.
•
To clean the outside of the washing machine,
use a neutral detergent and a damp cloth.
•
Do not use abrasive detergents.
•
Do not attempt to force the door open.
•
If necessary, the power cable may be replaced
with an identical one obtained from our AfterSales Service. The power cable must only be
replaced by a qualified technician.
6.EC Declaration of Conformity
•
This washing machine has been designed,
constructed and distributed in co mpliance with
the safety requirements of EC Directives:
73/23/EEC Low Voltage Directive
89/336/EEC EMC Directive
93/68/EEC CE Marking Directive
4
Black Process Plate
3gb10011.fm5 Page 5 Monday, June 18, 2001 1:08 PM
DESCRIPTION OF THE WASHING MACHINE
1.
Worktop
2.
Control panel
3.
Detergent dispenser
4.
After-Sales Service sticker
(on the back side of the door)
5.
Door
6.
Door handle
•
To open the door press the
button on the inside of the
handle and pull
•
Close the door by pushing it
firmly (the lock will click into
place)
7.
Filter (behind cover)
8.
Adjustable foot
PREPARATION OF THE WASHING
Sort the laundry
1.
Sort the laundry according to…
• Type of fabric / care label symbol
Cottons, mixed fibres, easy care/synthetics,
wool, handwashed items.
• Colour
Separate whites and coloureds. Wash new
coloured items separately.
• Size
Wash items of different sizes in the same load to
improve washing efficiency and distribution in
the drum.
• Fabric delicacy
Wash delicate articles separately: use a special
programme for Pure New Wool , curtains and
other delicates. Always remove curtain glides or
wash curtains with the glides inside a cotton bag.
Use the special program for handwash fabrics. Wash
stockings, belts and other small items or articles with
hooks (e.g. bras) in special cotton bags for washing
machines or in zipped pillow cases.
2.Empty pockets
Coins, safety pins and similar items can damage
of your appliance drum and tub.
3.Fasteners
Close zips and fasten buttons or hooks; loose
belts or ribbons should be tied together.
Stain removal
•
Blood, milk, egg and other organic substances
are generally removed by the enzyme phase of
the programme.
•
To remove red wine, coffee, tea, grass and fruit
stains etc. add a stain removing agent in detergent
dispenser compartment or chlorine bleach in
compartment (depending on model).
•
Particularly stubborn stains should be treated
before the wash.
Loading the laundry
1.
Open the door.
2.
Unfold the laundry and place it loosely in the drum.
Follow loads recommended in the programme chart:
Overloading will result in unsatisfactory washing
results and creased laundry.
3.
Close the door.
5
Black Process Plate
3gb10011.fm5 Page 6 Monday, June 18, 2001 1:08 PM
DETERGENTS AND ADDITIVES
Choice of the right detergent and additives
The type of detergent depends on:
•
type of fabric (cottons, easy care/synthetics,
delicate items, wool).
Note:
•
•
•
Notes:
Whitish residues on dark fabrics are caused by
insoluble detergents components used in modern
phosphate-free powder detergents.
If you notice this problem, shake or brush the
affected items or use a liquid detergent.
Keep detergents and additives in a dry place and
out of reach of children.
Use only detergents and additives specifically
produced for domestic washing machines.
If you use descaling agents, dyes or bleaches,
make sure they are suitable for washing machine
use. Descaler could contain components that can
attack parts of your washing machine.
Do not use solvents (turpentine, benzine, etc.).
Do not machine wash fabrics that have been
treated with solvents or flammable liquids.
use only specific detergents for wool.
colour;
washing temperature;
degree and type of soiling.
Dosage
Follow the instructions on the detergent pack in
relation to:
•
the degree and type of soiling;
•
the size of the load:
•
full load: follow the detergent
manufacturer’s instructions;
•
half load: 3/4 the amount used for a full
load;
•
minimum load (about 1 kg): half the amount
used for a full load;
•
water hardness in your area (ask for
information from your water company): soft
water requires less detergent than hard
water.
Notes:
Too much detergent can result in excess foam
formation, and the reduction of washing
efficiency. If the appliance detects excessive foam
it may prevent spinning.
Insufficient detergent may result in: grey laundry,
deposits on the drum, tub and heater.
You can use liquid detergent in the “Prewash”
phase for programmes with this option. In this
case put only powder detergents in the
compartment for the main wash .
When using concentrated fabric softeners, add
water in the detergent dispenser up to
mark.
To prevent dispensing problems when using highly
concentrated powder and liquid detergents, use
the special detergent ball or bag supplied with the
detergent and place it inside the drum.
“MAX”
level
Water hardness:
Water hardness
area
1
2
3
4
6
Black Process Plate
soft water requires less detergent
Characteristics German scale
soft
average
hard
very hard
°dH
0-7
7-14
14-21
over 21
French scale
°fH
0-12
12-25
25-37
over 37
Clarke scale
°eH
0-9
9-17
17-26
over 26
Loading...