1gb58913.fm Page 9 Friday, March 5, 2004 12:29 PM
CONTENTS |
|
|
GB |
|
|
|
|
|
|
BEFORE USING THE GLASS CERAMIC HOB |
PAGE 10 |
|
||
|
|
|
|
|
INSTALLATION |
PAGE 10 |
|
||
|
|
|
|
|
ELECTRICAL CONNECTION |
PAGE 11 |
|
||
|
|
|
|
|
ENERGY SAVING TIPS |
PAGE 12 |
|
||
|
|
|
|
|
PROTECTING THE ENVIRONMENT |
PAGE 12 |
|
||
|
|
|
|
|
PRECAUTIONS AND GENERAL |
|
|
|
|
RECOMMENDATIONS |
PAGE 12 |
|
||
|
|
|
|
|
COOKTOP ACCESSORIES |
PAGE 13 |
|
||
|
|
|
|
|
CARE AND MAINTENANCE OF THE |
|
|
|
|
GLASS-CERAMIC COOKTOP |
PAGE 13 |
|
||
|
|
|
|
|
TROUBLESHOOTING GUIDE |
PAGE 13 |
|
||
|
|
|
|
|
AFTER SALES SERVICE |
PAGE 14 |
|
9
1gb58913.fm Page 10 Friday, March 5, 2004 12:29 PM
BEFORE USING THE GLASS CERAMIC HOB
•To make the most of your new appliances read the users instructions carefully and keep them on hand for consultation in the future.
INSTALLATION
Cooktop
•The cooktop must be set into a worktop between 20 mm and 50 mm thick.
•Insert a separator panel at a minimum distance of 90mm from the bottom of the hob so that it is inaccessible to the user.
•If the cooktop is to be installed next to a column unit, leave a distance of at least 100 mm from the edge of the cooktop to the side of the column unit.
•Cut an opening in the worktop of the dimensions shown in the Product Description Sheet supplied separately.
•If not already present, fit the supplied seal to the cooktop flange after cleaning the contact area as shown in the figure.
N.B.: Remove the protective film before installing the cooktop.
•If the worktop is made of wood, use the supplied spring clips and screws.
1.Position the 4 clips (D) as shown and at the specified dimensions.
2.Secure the clips using screws (E).
3.Fit the cooktop into the worktop.
•If the worktop is made of marble, plastic, ceramics, natural stone, etc., the cooktop must be secured with brackets (F) code 4819 404 78697 (to be requested from After-Sales Service).
1.Fit the cooktop into the worktop.
2.Position the 4 brackets (F) as shown in the figure, in accordance with the thickness of the worktop.
3.Fix the 4 screws (G) in holes (H).
10