Whirlpool DU640XTKQ, DUL300XTKB, DUL300XTKQ, DUL300XTKS, DUL300XTKT Dimension Guide
...
3/4" (1.9 cm)
insulation –
may be
compressed
(not used on
all models)
Undercounter Dishwasher
®
PRODUCT MODEL NUMBERS OVERALL DIMENSIONS
CABINET OPENING DIMENSIONS
DU640XTK
DUL300XTK
DUL300XTL
GU1100XTL
GU1101XTL
GU1108XTL
GU1200XTL
GU1200XTK
GU1500XTL
GU1500XTK
GU630XTL
GU640XTL
Electrical: 120-volt, 60-Hz, AC-only, 15- or
20-amp. electrical supply. Use copper wire only. A
time-delay fuse or circuit breaker and separate
circuit is recommended.
Water: A hot water line with 20-120 psi
(138-862 kPa) water pressure. Water temperature
must be 120°F (49°C) at dishwasher. Use 3/8" O.D.
copper tubing with compression fitting or flexible
stainless steel braided fill line (1/2" minimum plastic
tubing is optional but not recommended). Use a 90°
elbow with 3/8" N.P.T. external pipe threads on one
end to connect to water inlet valve. Do not solder
within 6" (15.2 cm) from water inlet valve.
Drain: Use the new drain hose supplied with your
dishwasher. If this is not suitable, use a new drain
hose with a maximum length of 12 feet (3.7 m)
that meets all current AHAM/IAPMO test
standards, is resistant to heat and detergent, and
fits the drain connector of the dishwasher. Must
have a high drain loop 20 inches (50.8 cm) above
the subfloor or floor. Connect drain hose to waste
tee or disposer inlet above drain trap in house
plumbing and 20 inches (50.8 cm) minimum
above the floor. An air gap must be used if the
drain hose is connected to house plumbing lower
than 20 inches (50.8 cm) above subfloor or floor.
Use 1/2" minimum I.D. drain line fittings.
Grommet is required for electrical cable or power
supply cord hole cut in a metal cabinet.
Do NOT install dishwasher over carpeted floor.
25" (63,5)
24-1/2" (62,2 cm)
21" (53,3 cm)
23-7/8" (60,6 cm)
33-7/8"
(86 cm) min.
with wheels
removed
9"
(22,9 cm)
10"
(25,4 cm)
6-1/4"
(15,9 cm)***
6-1/4"
(15,9 cm)
‡
***
34" (86,4 cm) min.*
2"
(5,1 cm)
‡
2-1/2"
(6,4 cm)
‡
4"
(10,2 cm)
‡
3"
(7,6 cm)
‡
2"
(5,1 cm)
clear area
‡
4-1/4"
(10,8 cm)
‡
1-3/4"
(4,4 cm)
‡
1-3/4"
(4,4 cm)
‡
24" (61 cm)
min.
24" (61 cm)**
All surfaces must be free from
intrusions
*Measured from the lowest point on the underside of countertop.
May be reduced to 33-7/8" (86 cm) by removing wheels from dishwasher.
**Minimum, measured from narrowest point of opening.
***Maybe increased to 6-7/8" (17.5 cm) if height of opening is 34-1/2"
(87.6 cm) at lowest point.
‡
Both sides
Drain hose and power supply line should enter
through the right side of opening in shaded areas.
Drain hose size: 1-1/2" (3.8 cm)
Power supply line hole-direct wired: 3/4" (1.9 cm)
Power supply line hole-with plug: 1-1/2" (3.8 cm)
Water line should enter through the
left side of opening in shaded areas.
Minimum 1/2" (12,7 mm) hole.
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Ref. 8269550 Rev. A
04-14-04
Loading...