Whirlpool DLCE 91469, DLCE 71469 User Manual

Gebrauchsanweisung
Instructions for use
Mode d’emploi
Gebruiksaanwijzing
Istruzioni per l’uso
Brugsanvisning
Bruksanvisning
Käyttöohje
Instrucciones para el uso
Instrukcje użytkowania
Használati utasítás
ИнструкциЯ за употреба
Қолдану бойынша нұсқаулық
Návod k použití
Návod na použitie
Instruc∑iuni de utilizare
Инструкции по эксплуатации
Інструкція з експлуатації
1
a
b
c
d
e
f
g
( )
2
5
10
6
11
7
12
3
8
B
13
4
9
A
14
INTENDED USE
This washing machine is exclusively destined to treat machine washable laundry in quantities which are usual for private households.
Observe the instructions given in these Instructions for Use and the Programme Chart when using the washing machine
Keep these Instructions for Use and the Programme Chart; if you pass on the washing machine to another person, also give him/her the Instructions for Use and the Programme Chart.
SAFETY AND GENERAL RECOMMENDATIONS
1. Safety instructions
The washing machine is
appropriate for indoor use only.
Do not store flammable fluids
near the appliance
Children must not be allowed to
play with the washing machine or to climb into the drum.
The washing machine can
be operated by children from the age of 8 years up, as well as by people with reduced physical, sensory or mental capabilities or lack of experience and knowledge, provided they are supervised or instructed regarding the safe use of the washing machine and they understand the dangers resulting from the use. Children must not play with the washing machine. Care and maintenance works on the washing machine must not be carried out by children without being supervised.
Do not operate the washing
machine at temperatures below 5°C.
For freestanding models: if you
want to place a dryer on top of your washing machine, first contact our After-Sales Service or your specialist dealer to verify if this is possible. This is only admitted if the dryer is
fixed on the washing machine by using an appropriate stacking kit available through our After-Sales Service or your specialist dealer.
Do not leave the appliance
plugged in when not in use.
Turn off the tap when not in
use.
Before any cleaning and
maintenance switch off the machine or disconnect it from the mains supply.
Never open the door forcibly or
use it as a step.
If necessary, the power cable
may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician or by our After-Sales Service.
If your washing machine is a
built-in model:
- do not operate it unless it is
built-in
- you must not remove the up
cover.
Children younger than 3 years
should be kept away from the washing machine, unless they are continuously supervised.
The ventilation openings in the
base of the washing machine must not be obstructed by thick carpet.
EN 1
If you want to place the
washing machine on a pedestal or any raised position, make sure that this pedestal
- is solid enough for the
high weight of the washing machine
- is completely level
- is large enough, and that the
surrounding area limits the washing machine so that it cannot move out of position in case of extraordinary operation conditions.
2. Packing
The packaging materials are 100% recyclable
and bear the recycling symbol . Adhere to local regulations when disposing of packaging material.
3. Disposing of packaging and old washing machines
The washing machine is built from reusable
materials. It must be disposed of in compliance with current local waste disposal regulations.
• Before scrapping, remove all detergent residues and cut off the power cable so that the washing machine is made unusable.
• This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
4. Frost
• Do not place the washing machine in a room prone to frost. If you must, make sure that the washingmachine is completely drained after each wash:
• Remove inlet hose(s) from water tap and let the water flow out completely.
• Remove drain hose from siphon or handwash basin and let the water flow out completely.
• Empty residual water inside the machine by following the instructions in the chapter “Draining Residual Water”.
5. EC Declaration of Conformity
• The appliance conforms to the following European Standards: 2006/95/EC Low Voltage Directive 2004/108/EC Electromagnetic Compatibility Directive.
The Manufacturer is not liable for any damage to laundry resulting from inadequate or incorrect fabric care instructions which have been provided with the garment or article.
EN 2
BEFORE USING THE WASHING MACHINE
1. Removing the packaging and inspection
After unpacking, make sure that the washing
machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer.
Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous.
If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating.
2. Remove the transport bolts
The washing machine is fitted with transport
bolts to avoid any possible damage to the interior during transport. Before using the machine, it is imperative that the transport bolts are removed.
After their removal, cover the openings with the 4 enclosed plastic caps.
3. Install the washing machine
Remove the protective film from the control panel
(if available on your model).
Move the appliance without lifting it by the worktop.
Install the appliance on a solid and level floor
surface, preferably in a corner of the room.
Make sure that all four feet are stable and resting on the floor and then check that the washing machine is perfectly level (use a spirit level).
In case of wooden or so-called “floating floors” (for instance certain parquet or laminate floors), place the appliance on a sheet of plywood at least 60 x 60 cm wide/deep and at least 3 cm thick which is secured to the floor.
Make sure that the ventilation openings in the base of your washing machine (if available on your model) are not obstructed by a carpet or other material.
4. Water inlet
Connect the water inlet hose(s) to the drinking
water supply in accordance with the regulations of your local water company.
For models with one inlet valve: cold water
For models with two inlet valves: cold AND hot
water, or cold water only (see chapter “Installation Guide”).
Water tap: 3/4” threaded hose connector
Water pressure (flow pressure): 100-1000 kPa
(1-10 bar).
Use only new hoses to connect the washing machine to the water supply. Used hoses must not be used and should be discarded.
For models with hot fill: the hot water inlet temperature must not exceed 60°C.
5. Drain
Firmly connect the drain hose to the siphon, or
another outlet for drain water.
If the washing machine is connected to an integrated drainage system, ensure the latter is equipped with a vent to avoid simultaneous load­ing and draining of water (siphoning effect).
6. Electrical connection
• Electrical connections must be carried out by a qualified technician in compliance with the manu­facturer’s instructions and current standard safety regulations.
• Data regarding voltage, power consumption andprotection requirements is given on the inside of the door.
• The appliance must be connected to the mains by means of a socket with an earth connection in accordance with current regulations. The washing machine must be earthed by law. The manufac­turer declines all liability for damage to property or injury to persons or animals due to non-compli­ance with the directions given above.
• Do not use extension leads or multiple sockets.
• Access to the mains plug or disconnection from the mains supply via a double-pole switch must be ensured at all times after the installation.
• Do not operate the washing machine if it has been damaged during transport. Inform the After-Sales Service.
• Mains cable replacement is only to be carried out by After-Sales Service.
• When using a residual current circuit breaker (RCCB), only use a model marked with .
EN 3
Loading...
+ 11 hidden pages