Whirlpool BMZH 5069/AL, BLZH 5069/IN, BSZH 5069/IN, BLZH 5069/AL, BMZH 5069/IN INSTRUCTION FOR USE

4

4gb53171.fm5 Page 4 Wednesday, June 19, 2002 1:14 PM

Instructions for use

Precautions and general recommendations
Installation
Electrical connection
Oven accessories
Cleaning the oven and accessories
Troubleshooting guide
After Sales-Service

4

4gb53171.fm5 Page 5 Wednesday, June 19, 2002 1:14 PM

Precautions and general recommendations

Before using the oven

• To make the most of your

new oven read the users
instructions carefully and
keep them on hand for
consultation in the future.

• Remove the cardboard
protections and the
protective plastic film.

• Remove the accessories
from the oven and heat it
at 200°C for about an hour
to eliminate the smell of
protective grease and
insulating materials. Keep
the window open during
this procedure.

Protecting the environment

1. Packing

• The packaging material is

100% recyclable and it is
marked with the recycle
symbol .

2. Appliance

• The appliance is built from

recyclable materials.
If you decide to scrap the
appliance please observe
local waste disposal
regulations. When you
scrap them, cut off the
power cords so that the
appliance cannot be
connected to the mains.

Declaration of
conformity CE:

• This oven is designed to

• It is designed solely for use

• This oven is designed, built

come into contact with
foodstuffs and it is
constructed in compliance
with Directive 89/109/EEC.

as a domestic cooking
appliance. Any other use
of the oven (e.g. for room
heating) is considered as
improper use and
potentially dangerous.

and sold in compliance
with:

- the safety requirements
of “Low Voltage”
Directive 73/23/EEC;

- the protection
requirements of EMC
Directive 89/336/EEC;

- the requirements of
Directive 93/68/EEC.

5

4gb53171.fm5 Page 6 Wednesday, June 19, 2002 1:14 PM

Precautions and general recommendations

• Never stand or sit on the
oven open door. Never
hang any weight at the
handle of the oven door
when open.

• Use oven gloves to
remove baking trays and
accessories when the
oven is hot.

• Do not cover the
bottom of the oven
with aluminium foil.

• Do not place inflammable

material in the oven - risk
of fire if the oven is
inadvertently switched
on.

Precautions and general
recommendations

• Before any maintenance

on the appliances
disconnect them from the
power supply.

• Keep children away from
the oven when it is in use
and when its has just
been switched off.

• The oven must be
repaired or adjusted only
by a qualified technician.

• Make sure that the
electrical wires of other
electrical appliances near
the oven do not come
into contact with hot
parts and do not become
entrapped in the oven
door.

• During the cooking
process, water evaporates
from food.

All ovens require this
steam and other fumes to
be vented from the oven
cavity. For reasons of safety
and aesthetics, we have
determined that an
opening at the bottom of
the door is the optimum
solution.
Consequently, vapour may
be seen to be coming from
this area on occasions
(see picture).

• This is a normal occurrence
and the bottom trim can
be cleaned after removal
of the door as described on
“Cleaning the oven and its
accessories”.

• Heavy weights must not be
placed on the open door as
this may result in damage
to the cavity and hinges.
Max weight: 7 kg (15lbs).

F

umes

e

xhau

s

t

6

4gb53171.fm5 Page 7 Wednesday, June 19, 2002 1:14 PM

Installation

Technical information for
the installer

Oven

• After removing the oven

from its packaging,
before making the
connections place it on
the polystyrene foam
base to protect it from
damage.

• Do not attempt to lift the
oven by the handle.

• Lift at the sides as shown
in the figure (see arrow).

• Check that the appliance
has not been damaged in
transit.

• Oven dimensions and
kitchen unit dimensions
are shown in the figure
opposite.

• Kitchen units in contact
with the oven must be heat
resistant (80°C).

• If plastic laminates or
cement are not sufficiently
heat-resistant, warping,
bubbling or detachment of
the finish may result.

• Install the oven in the
housing, lifting it at the
sides, taking care not to
trap the wires of the
electrical supply cable.

• Install the oven in the
housing, lifting it at the
sides, taking care not to
trap the wires of the
electrical supply cable.

7