Whirlpool AWZ 3522, AWZ 221 GD, AWZ 3466 INSTRUCTION FOR USE

CONTENTS
QUICK REFERENCE GUIDE
PROGRAMME CHART
PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING
INSTRUCTIONS FOR USE
BOOKLET
SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS
ELECTRICAL CONNECTION SAFETY ADVICES AND GENERAL
RECOMMENDATIONS DESCRIPTION OF THE DRYER REMINDER - MAINTENANCE AND CLEANING
VENT CONNECTION DOOR REVERSIBILITY TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE
PAGE
PAGE
PAGE
PAGE
PAGE PAGE
PAGE
PAGE
60 61
62 64 64
65 66 67
59
SAFETY ADVICES BEFORE USING THE DRYER / CONNECTIONS
1. Removing the packaging and check
After unpacking, make sure that the dryer is
undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer. Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children, as they are potentially dangerous. If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating.
2. Electrical Connections
Electrical connections must be carried out by a
qualified technician in compliance with the manufacturer’s instructions and current standard safety regulations. Electrical connection must comply with local
Electricity Board regulations. Voltage information, power consumption and the
required fuse protection is shown on the rating plate mounted at the rear of the dryer. The manufacturer cannot accept any liability for
personal injury or damage to property resulting from failure to adhere to these instructions. The dryer must be earthed as prescribed by law.
Do not use extension leads or multiple adaptors.
Do not use electrical portable outlet devices.
Before any maintenance on the dryer disconnect it
from the mains supply. Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales Service technicians. Mains cable replacement is only to be carried out by
After-Sales Service. After installation access to the mains plug has to be
guaranteed, or the all-pole disconnection has to be possible with a switch.
3. Installation
Do not install your dryer where it can be subject to
extreme conditions, such as: poor ventilation, temperatures below 5°C or above 35°C. The appliance must not be installed behind a
lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer, in such a way that a full opening of the tumble dryer door is restricted. Take care not to install the dryer on a deep-pile carpet.
Take care not to trap the mains cable between the
dryer and the wall. The exhaust air must not be discharged into a flue
which is used for exhausting fumes from appliances burning gas or other fuels. Pay attention that the air-inlet openings are
unobstructed.
Stability:
When installing the dryer always carefully level the dryer adjusting the two feet and check the correct levelling with a spirit level.
To built in the dryer
For security reasons do not remove the worktop.
Connect the dryer to an external ventilation system
in order to prevent steam from damaging your furniture during the years.
Stacking kit
Your dryer can be stacked on top of your front loading washing machine. Please contact your dealer or our After Sales Service.
Minimum housing dimensions:
Width: 600 mm Height: 855 mm Depth: 560 mm
60
ELECTRICAL CONNECTION
1) For Great Britain only Warning - this appliance must be earthed Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows:
Remove the fuse cover (A) and fuse (B).
1.
Fit replacement 13A fuse into fuse cover.
2.
Refit both into plug.
3. Important:
The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store.
2) For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type.
3) Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations.
61
SAFETY ADVICES AND GENERAL RECOMMENDATIONS
If the lint filter mesh is clogged, clean it with water
1. Packing
The packing box may be fully recycled as confirmed by the recycling symbol .
2. Energy saving tips
Always dry a full load: depending on the type of
laundry and the programme/drying time. By preference use the maximum spin speed allowed
by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle.
Do not overdry the laundry.
Clean the lint filter after
Place your dryer in a room with a temperature
between 15° C and 20° C. In case of higher temperature ventilate the room.
Always select the correct programme/drying time
for the load in order to obtain the desired drying results.
Select the gentle option only with small loads.
When drying cotton, for example. dry iron dry and
cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting.
3. Disposing of packaging and old Dryer:
The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations.
Before scrapping, cut off the power cable so that
the dryer cannot be connected to the mains.
4. Child safety:
Children must not be allowed to play with the dryer.
5. General recommendations:
The tumble dryer is intended only for drying textile
material washed in water. Always set the programme/time selector knob to
the “0” position after use.This prevents the dryer from being switched on accidentally.
Before cleaning or carrying out maintenance,
switch off the dryer and disconnect it from the mains supply.
To clean the outside of the dryer, use a neutral
detergent and a damp cloth. Do not use abrasive detergents.
Wipe away lint from the door seal and the door
using a damp cloth.
every
drying cycle.
and a soft brush. Since lint can go through the filter it is necessary to
clean, from time to time, the complete filter area (including below the filter) with a brush, a damp cloth or with a vacuum cleaner. If necessary, the power cable may be replaced with
an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician.
6. To minimize the risk of fire in tumble dryer, the following should be observed:
Do not use inflammable cleansing agents.
Do not use the tumble dryer if industrial chemicals
have been used for cleaning. Garments treated or contaminated with flammable
cleaning sprays or liquids such as petrol, cooking oil or aerosol sprays must not be put in this dryer.
Items that have been soiled with substances such as
cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers should be washed in hot water with an extra amount of detergent before being dried in the tumble dryer.
Oil-affected item can ignite spontanously, especially
when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the items can become hot enough to catch fire. Piling, stacking or storing oil-affected items can prevent heat from escaping and so create a fire hazard.
The appliance is not intended for use by persons
(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsble for their safety. Children should be supervised to ensure that they do not play with the appliance. If it is unavoidable that fabrics contain vegetable or
cooking oil or have been contaminated by hair care products b placed in a tumble dryer they should first be washed in hot water with extra detergent ­this will reduce, but not eliminate, the hazard. Do not dry unwashed items in the tumble dryer.
Items such as foam rubber (latex foam), shower
caps, waterproof textiles, rubber backed articles and clothes or pillows fitted with foam rubber pads should not be dried in the tumble dryer.
62
Fabric softeners, or similar products, should be
used as specified by the fabric softener instructions. Lighters must not be left in pockets.
Never use and store flammable materials nearby
the dryer.
This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product.
The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
Attention rear panel can be hot.
EC Declaration of Conformity
This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives:
2006/95/EG Low Voltage Directive
2004/108/EC Electromagnetic Compatibility
Directive
The dryer must be used in the household for the described uses.
PLEASE READ BOOKLET
INSTRUCTIONS FOR USE!
63
DESCRIPTION OF THE DRYER
Work top
A.
Contact pin
B.
Door
C.
To open the door: pull the handle
To close the door: push gently until closed.
Filter
D.
A
B
D
C
REMINDER - MAINTENANCE AND CLEANING
EACH DRYING CYCLE
• Clean the lint filter at the end of every drying cycle.
Open the door. Pull the filter upwards. Remove lint using a soft brush or your fingertips. Push the filter back into place.
EACH THREE MONTHS
Clean venthose and connection regularly to
avoid blockage due to lint or foreign objects.
64
VENT CONNECTION
Normally the hose and adaptor are not supplied; the accessory kit, available at your dealer or our After Sales Service, should be used.
Installing the vent hose
Place a towel or the packing material on the right-hand side next
A.
to the dryer. Place the dryer on its right-hand side (seen from the front) on the
B.
towel or the packing material. Push the adapter into the hose (see illustration). Attach the air vent
C.
hose adapter to the connection located under the dryer and lock it by means of the foreseen lugs.
Venting outside
Without kinking it, lead the vent hose outside (inside diameter 10
cm, maximum length with two bends 3 m). Ensure that the vent hose does not sag when stacking the dryer on
a washing machine. It should only be placed horizontally or upwards. Do not connect to ventilation systems protected by fly nets. These
can become clogged and cause malfunctioning of the dryer. Do not connect the air vent hose to a chimney or to a mechanical
ventilation extractor duct. Do not connect the vent hose to the heating system. Only connect
the hose to ventilation systems insulated against humidity. Please provide adequate ventilation to avoid the back flow of gases
into the room from appliances burning other fuels, including open fires.
Dryer operation without vent hose
Only use the dryer in a large, well-ventilated room.
Keep the room free of dust and lint.
A minimum distance of 10 cm between rear of appliance and the wall must be observed.
C
Dryer placed close to the wall; venting to the left or right
Install the dryer by using the bi-directional kit, available at your dealer.
IMPORTANT
For example, alternative to be used.
• Do not connect to ventilation systems protected by fly nets. These can become clogged and cause malfunctioning of the dryer.
65
DOOR REVERSIBILITY
Door Reversibility A. Unplug the dryer.
Open the door.
B.
Using a spanner, turn the contact pin on the inside of the door
C.
(top) through 90° and remove it.
Remove the 2 door hinge screws, followed by the door.
D.
Unscrew the 2 screws above and below the door lock system.
E.
C
C
Removing the door lock: using a screwdriver, press down on the
F.
small rib in the upper opening and extract the door lock by pulling it towards you.
Reverse the door:
G.
Fasten the door on the desired side using the 2 screws.
H.
Insert the door lock system on the opposite side and lock it
I.
securely. Fix the 2 screws above and below the door lock system.
J.
Replace the contact pin in the inside of the door (top).
K.
66
D
E
F
E
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE
Troubleshooting Guide If a fault occurs, before contacting our After-
Sales Service, make the following checks to try and remedy the problem:
Drying takes too long / laundry is not dry enough:
Was the correct programme selected?
Was the inserted laundry too wet (Washing
machine spin speed less than 800 rpm)? Is the lint filter dirty (filter indicator lamp on)?
Does “END” and “Anti-Crease” LED’s are lights
up? - The drying cycle is terminated, the laundry can be taken out.
T
he dryer does not operate:
(following a power failure and/or interruption to the mains supply, always press the Start button).
Is the plug properly inserted into the mains
electricity socket? Is there a power failure?
Has the fuse blown?
Is the door well closed?
Has the programme been selected?
Has the start delay option been selected?
Has the
Start (Pause)
button been pressed?
Lint filter indicator lamp light on:
Is the lint filter clean?
Is the vent hose blocked?
Is the outside vent hose adaptor blocked ?
After-Sales Service If, after carrying out the above checks the
malfunction persists or appears again, turn the dryer off and call our After-Sales Service (refer to guarantee).
Please specify:
The nature of the fault.
The dryer type and model.
The service code (the number after the word
Service on the adhesive rating plate) on the right­hand side when the door is open.
Your full address and phone number.
67
Loading...