Whirlpool AWT 2466 INSTRUCTION FOR USE

GB AWT 2466 MAGIC PROGRAMME CHART
A. Programme Selection Knob B. Temperature Selection Knob C. “Spin Speed Selection” Knob D. “On/Off” Button
B CA D
: option / Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is zero in this programme.
Programme
Cotton with prewash
Synthetic with prewash
Delicate with prewash
Cotton
Coloured Cotton
Mixed Cotton/
Synthetics Synthetics
Delicate
Wool
Silk
Rinse + Gentle Spin
Rinse + Spin
Spin
Gentle spin
Drain
Care
Labels
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses. Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of
cotton and linen. Normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton
and linen. Normally soiled overalls and sportswear made of cotton, polyester, polyamide and blends
with cotton. Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),
polyamide (Perlon, Nylon) or blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine
washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning. Programme for treating delicate laundry with starch or softener.
Programme for treating cotton or linen laundry with starch or softener.
Programme to spin cotton or linen laundry intensively with maximum spin speed.
Programme to spin delicate laundry gently with a restricted spin speed.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
Type of wash/ Notes
load
kg
5.0
2.0
1.5
5.0
3.0
1.5
2.0
1.5
1.0
1.0
2.0
5.0
5.0
2.0
——— — ——— — — — —
Detergents and additives Special Options Temp e ra-
Pre-
Main
wash
Wash
1)
Yes
Yes
1)
Yes
Yes
1)
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
— ——
——
Softener Bleach Rapid Half
❉❉—❉❉❉ ❉
——
——— —
❉❉❉❉❉❉ ❉
——
❉ ❉
❉ ❉
❉ ❉
❉❉ ❉ ❉
— ——
——— — ——— —
——— — ———
———
Intensive
Load
Rinse
Rinse Hold
❉❉❉
❉❉❉
❉❉❉
❉❉ ❉❉
ture
Max. 95 600 Max. 60 600
Max. 40 600
Max. 95 600
Max. 60 600 Max. 60 600 Max. 60 600
Max. 40 600
Max. 40 600
Max. 30
°C
— ——— ——— — — — ——— ——— — — —
Max.
Spin
Speed
rpm
600 600 600 600
2)
N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10489
CONSUMPTION DATA
Programme
Temperature
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes) Cotton 95 5.0 63* 1.80 2:05 Cotton 60 5.0 55 0.95 2:05 Cotton 40 5.0 55 0.55 2:05
Mixed Cotton / Synthetics 60 2.0 56 0.80 1:30
Synthetics 40 2.0 56 0.40 1:30
Delicate 40 1.5 60 0.55 0:45
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and check that they are properly locked.
2. Add detergents and additives into the dispenser to no more then the
“MAX”
level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.
“Rapid” button
• For fast, energy saving wash cycles.
• Ideally suited for small loads consisting of lightly soiled laundry.
“Half Load” button
• Can be used for small loads and lightly soiled laundry.
• Reduces the water consumption especially during the rinses.
desired temperature.
5. Turn the
spin speed selector knob
to the desired spin speed. If the spin speed “ ” is selected, the final spin is cancelled. The programme ends with a drain cycle.
“Intensive Rinse” button
• The amount of water is increased to ensure a more intensive rinse.
• This option is particularly suitable for areas with very soft water or washing linen laundry for people with skin allergies.
“Rinse Hold” button
• The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.
• This option is particularly recommended for the “Synthetics” and “Delicate” programmes.
• This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.
the programme selector knob stops
Note:
on .
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle.
• If you do not wish to spin the clothes, press the “
” button, turn the programme
On/Off
selector knob to the “Drain” programme and press the “
On/Off
” button again.
PROGRAMME START
Turn on the tap and press the “ The indicator light of the “
: If there is a power interruption or if the
Note
On/Off
” button.
On/Off
” button lights up.
appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.
END OF WASH CYCLE
• The programme selector knob is in the Stop position.
1. Press the “
” button to switch off the
On/Off
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drum doors and unload
the machine.
to allow the inside of the appliance to dry
Leave the lid open for some time
.
CHANGE THE PROGRAMME DURING THE WASH CYCLE
1. Switch off the machine by pressing the
On/Off
” button.
2. Select the new programme.
3. Start programme by pressing the “
On/Off
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the programme for a certain time and continue it later:
1. Press the “
On/Off
” button.
2. After the desired pause, press again the
“On/Off”
button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
On/Off
” button.
2. Set the programme selector to “Drain” .
3. Press the “
” button again to start the
On/Off
“Drain” programme .
Whirlpool is a registered trademark of Whirlpool USA
5019 312 10489
Loading...