Whirlpool AWA 5858 INSTRUCTION FOR USE

GB
AWA 5858
B CA D
Programme
Cotton with prewash
Prélav. Coton
Synthetic with prewash
Prélav. Synthét.
Delicate with prewash
Prélav. Délicat
Cotton
Coton
Coloured Cotton
Couleur
Daily Mixed
Synthetic
Synthétique
Synthetic short
Synthétique Fragile
Delicate
Délicat
Wool
Laine
Silk
Soie
Rinse + Gentle Spin
Rinçage & Essorage Doux
Rinse + Spin
Rinçage & Essorage
Spin
Essorage
Gentle spin
Essorage doux
Drain
Vidange
N.B.This machine is controlled by sensors. Please avoid excessive detergent dosing.
Care
Labels
Type of wash / Notes
Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses.
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Normally soiled bed linen, table linen and underwear, towels, shirts etc., made of cotton and linen.
Slightly to normally soiled textiles made of cotton and/or synthetics.
Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton.
Normally soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton.
Curtains and delicate clothing, dresses, skirts, shirts and blouses.
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.
If you select “Rinse Hold” do not leave items to soak for too long.
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. No spinning.
Programme for treating delicate laundry with starch or softener.
Programme for treating cotton or linen laundry with starch or softener.
Programme to spin cotton or linen laundry intensively with maximum spin speed.
Programme to spin delicate laundry gently with a restricted spin speed.
Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.
A. Programme Selection Knob B. Temperature Selection Knob C. “Spin Speed Selection” Knob D. “On/Off” Button
Max. load
5.0
2.0
1.5
5.0
3.0
3.0
2.0
1.5
1.5
1.0
1.0
2.0
5.0
5.0
2.0
—————— — — —
: option / Yes: dosing required
1)
Do not use liquid detergents.
2)
For improved garment care, spin speed is restricted to 800 rpm in this programme.
3)
For improved garment care, spin speed is zero in this programme.
Detergents and additives Special Options Tempera-
Prewash Main
1)
Yes
1)
Yes
1)
Yes
——
——
Softener Bleach Intensive
Wash
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
❉❉❉ ❉ ❉ ❉ ❉❉❉ ❉ ❉
❉ ❉
❉ ❉ ❉ ❉ ❉ ❉
Rinse
Rinçage
Plus
❉❉
——
❉❉ ❉❉ ❉❉
❉❉
——
——
——
——
——
Rinse
Hold
Arrêt Cuve
Pleine
❉ ❉ ❉ ❉ ❉
ture
°C
Max. 90 850
Max. 60
Max. 40
Max. 90 850
Max. 60 850
Max. 60 850
Max. 60
Max. 60
Max. 40
Max. 40
Max. 30
——— —— — —
——— —— — —
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 00109
Max. Spin
Speed
rpm
800
800
800
800
800
800
800
850
850
800
2)
2)
2)
2)
2)
2)
3)
2)
2)
CONSUMPTION DATA
Temperature Selector
Programme
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes) Cotton 90 5.0 63* 1.80 2:05 Cotton 60 5.0 55 1.15 2:05 Cotton 40 5.0 55 0.55 2:05
Daily Mixed 40 3.0 49 0.48 1:00
Synthetic 60 2.0 56 0.80 1:35 Synthetic 40 2.0 50 0.40 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the Energy Label refer to the programme Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the
water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
1. Load the machine, close the drum doors and check that they are properly locked.
2. Add detergents and additives into the dispenser to no more then the
MAX
level mark, as
follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet.
Intensive Rinse button
One rinse cycle is added to ensure a more intensive rinse.
This option is particularly suitable for areas with very soft water, washing baby linen and people with detergents allergies.
Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
desired temperature.
5. Turn the
spin speed selector knob
to the desired spin speed. If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. The programme ends with a drain cycle.
Rinse Hold button
The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading.
• This option is particularly recommended for the “Synthetic”, “Delicate” and “Daily Mixed”
programmes.
This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only.
Note:
the programme selector knob stops on .
Appliance in Rinse Hold”:
Press the Rinse Hold button again: the programme will terminate automatically with the selected spin cycle.
If you do not wish to spin the clothes, press the
On/Off
button, turn the programme selector
knob to the Drain programme and press the
On/Off
button again.
PROGRAMME START
Turn on the tap and press the The indicator light of the
On/Off
On/Off
button.
button lights
up.
Note
: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted.
END OF WASH CYCLE
The programme selector knob is in the Stop position “”.
1. Press the
On/Off
button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
Open the lid and the drum doors and unload
5.
the machine.
CHANGE THE PROGRAMME DURING THE WASH CYCLE
1. Switch off the machine by pressing the
On/Off
button.
2. Select the new programme.
Start programme by pressing the
3.
On/Off
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the programme for a certain time and continue it later:
1. Press the
On/Off
button.
2. After the desired pause, press again the
On/Off
button.
CANCEL PROGRAMME
1. Switch off the machine by pressing the
On/Off
button.
2. Set the programme selector to “Drain”.
3. Press the
On/Off
button again to start the
Drain programme.
Whirlpool is a registered trademark of Whirlpool USA.
5019 312 00109
Loading...