Whirlpool ART 826-2/G, ART 868/G/BR, ART 868/G PROGRAM CHART

TABLE OF CONTENTS

DESCRIPTION OF THE APPLIANCE PAGE 13

THE PANEL PAGE 14

BEFORE USING YOUR APPLIANCE PAGE 15

PRECAUTIONS AND GENERAL SUGGESTIONS PAGE 15

HOW TO OPERATE THE REFRIGERATOR COMPARTMENT PAGE 16

HOW TO OPERATE THE FREEZER COMPARTMENT PAGE 17

HOW TO DEFROST THE FREEZER COMPARTMENT PAGE 19

HOW TO MAINTAIN THE APPLIANCE PAGE 20

TROUBLE SHOOTING GUIDE PAGE 21

AFTER-SALES SERVICE PAGE 21

INSTALLATION PAGE 22

DESCRIPTION OF THE APPLIANCE

A) Refrigerator compartment (for storing

fresh food)

1. Grids (adjustable in height). Depending

on the models:

• The inclination of the grid may be adjusted

• A flap on one of the grids can be lifted to fit bottles

2. Glass separator

3. Crispers

4. Refrigerator inner door liner with racks

5. Rating plate (at the side of the crispers)

B) Freezer compartment (marked for

freezing fresh foods and for storing commercially frozen foods and producing ice cubes)

6. Tray (if provided) for ice cubes and/or eutectics (cold packs) (dependent on model)

7. Freezing section

8. Ice cube trays

9. Storage baskets

10. Defrost water drain

11. Freezer inner door C) Removable plinth D) Control panel External/Internal

Commands

THE PANEL

External Commands Version

1. On button for the appliance

2. Green pilot lamp (operation of the

appliance)

3. Yellow pilot lamp for freezing

Internal Commands Version

4. Yellow pilot lamp button for freezing

5. Termostat knob for the appliance

6. Light switch

According to the model the commands of the appliance con be external and/or internal. The temperature adjusting is always

done through the internal knob (5).

BEFORE USING YOUR APPLIANCE

PRECAUTIONS AND GENERAL SUGGESTIONS

• After unpacking, please ensure that the appliance is undamaged and that the doors close tightly. Any damage must be reported to your dealer within 24 hours of receipt of the appliance.

• Let the appliance stand for 1 hour prior to

connecting it to the electricity supply.

• The package is recyclable and is marked with the recycling symbol .

• The appliance is built with re-usable material. When scrapping, follow the local environmental protection regulations.

• Please ensure that the installation and the electrical connection has been carried out following the manufacturer’s instructions and in compliance with local safety regulations.

• Only use the refrigerator compartment for the storage of fresh food, and the freezer compartment for the storage of frozen food, the freezing of fresh food and the production of ice cubes.

• After installation, please make sure that the appliance does not stand on the supply cord.

• Do not store glass containers with carbonated drinks in the freezer as they may explode.

• Do not eat ice cubes or ice lollies immediately after their removal from the freezer, as they may cause “cold” burns.

• Before any cleaning or maintenance operation, disconnect the appliance by switching off the electricity at the mains or by pulling the plug.

• Never allow children to operate, play with, or crawl inside the appliance.

Render the appliance inoperative by cutting the power-cable off and take it to the local disposal centres so that refrigeration compounds can be properly treated to avoid air pollution.

Conformity declaration

• This appliance incorporates parts intended to come into contact with foodstuffs and is in compliance with EEC directive 89/109.

This appliance has been designed, built and marketed in compliance with:

- the safety targets of the “Low Voltage”

EEC Directive 73/23;

- the protection requirements of the

“EMC” EEC Directive 89/336 amended by EEC Directive 93/68.

Information

This appliance is free of CFC’s (refrigerant circuit contains R134a) or free of HFC’s (refrigerant circuit contains R600a - Isobutane). For more details, please refer to the rating plate on the appliance.

For appliances with Isobutane (R600a)

The refrigerant Isobutane is a natural gas of high environmental compatibility but which is inflammable. Therefore, it is essential to ensure that the ducts of the refrigerant circuit do not get damaged.

+ 8 hidden pages