Whirlpool ART 628/H, KVA 1301/1, KVA 1408, KVA 1309/1, KVA 1301 PRODUCT SHEET

6gb33026.fm5 Page 1 Wednesday, February 28, 2001 5:03 PM

PRODUCT SHEET

GB

A.

Refrigerator compartment

B. Low temperature compartment

1.

Crisper drawer

6.

Ice cube tray (if provided, inside the

2.

Shelves / Shelf area

compartment)

7.

Low temperature compartment door.

3.

Thermostat control knob/light

4.Shelves

5.Rating plate (at the side of crisper drawer)

Least cold zone

Intermediate temperature zone

Coldest zone

Notes: The number of shelves and type of accessories may vary, depending on the model. All shelves and racks are removable.

Important: Refrigerator accessories must not be washed in a dishwasher.

D GB F NL E P I GR S N DK FIN

6gb33026.fm5 Page 2 Wednesday, February 28, 2001 5:03 PM

Refrigerator compartment controls

		A. Light switch cam
		B. Thermostat control
		reference
		C. Thermostat knob
		D. Switch (if provided)
		E. Light bulb (max 15 W)
Thermostat set to	MIN/1-2:	minimum refrigeration.
Thermostat set to MED/3-4: medium refrigeration.
Thermostat set to MAX/5-7: maximum refrigeration.
Thermostat set to	z:	no refrigeration, no light.

Recommended thermostat setting: MED/3-4 position.

Optimal performance is obtained at temperatures between +16°C and +32°C for appliances with climatic class “N” and at temperatures between +10°C and +32°C for appliances with climatic class “SN”.

The climatic class is indicated on the data plate inside the appliance.

Note: The ambient air temperature, the frequency of door opening and the position of the appliance can affect the internal temperatures of the refrigerator. These factors must be taken into account when setting the thermostat.

Removing the light bulb

To remove the light bulb, unscrew it anticlockwise (see figures).

Posizioning the appliance under the worktop

The appliance can be installed under a worktop (worktop height 850 mm from floor). Proceed as follows:

•First loosen the rear “A” and front “B” screws; then remove the appliance top (Fig.1).

•Make a vent outlet on the worktop (Fig. 2).

•Push the appliance under the worktop and secure at the front with the same screws “B” used for the top.

Observe the distance from the rear wall	FIG. 1	FIG. 2
indicated in (Fig. 2)

Printed in Italy 02/01

5019 602 33026 D GB F NL E P I GR S N DK FIN