Whirlpool AKS 310/NE INSTRUCTION FOR USE
AKS 310
GB
PRODUCT DESCRIPTION SHEET
2
1
5
3
Radiant cooking zone Ø 145
1.
Radiant cooking zone Ø 210
.
Radiant cooking zone Ø 145
.
Radiant cooking zone Ø 180
.
Display
.
mportant:
o avoid permanently damaging the glass-ceramic
op, do not use:
Pots with bottoms that are not perfectly flat.
Metal pots with enamelled bottom.
ny aesthetic defects (scratches, surface marks,
tc.) must be reported immediately upon
4
nstallation.
DIMENSIONS OF THE HOB (mm)
Type PLEAA 230 V ~ 50 Hz 5.7 kW
5019 519 01039
B
C
D
A
On/Off
B
Cooking zone selection and heat setting increase
To switch the hob on, hold down button A for about 2 seconds. The 4 cooking zone displays show
20 seconds none of the cooking zones is activated, the hob switches off automatically as a safety precaution.
Press one of the buttons
Select the heat setting required with buttons
same time to cancel all settings.
IMPORTANT:
heat setting, first press the selection button
“C”
or
CHILD SAFETY
The
function button. The Child Safety function locks all the hob's other functions, with the exception of the On/Off
button
holding down button
RESIDUAL HEAT INDICATOR.
When the cooking zone is switched off, the residual heat indicator
H
“0”
until the temperature of the hob returns within safety levels.
IMPORTANT:
heat setting triggers automatic switch-off of the cooking zone (for example, after around 1 hour at maximum heat setting,
the cooking zone switches off).
For safety reasons, the hob is equipped with an automatic cut-off function. Prolonged use of the same
the control is deactivated 10 seconds after the heat setting has been selected. To change the
.
“A”
. This function remains on even after the hob has been switched off and on again. It can cancelled by
“B”
corresponding to the cooking zone you intend to use.
function is switched on by holding down button
“D”
until the dot above the function button switches off.
“B”
“B”
C
Heat setting decrease
D
Child safety device
“C”
or
. Heat settings go from 1 to 9. Press buttons +/- at the
again, then proceed to change the setting, using buttons
“D”
until a dot lights up above the
“H”
remains on or flashes alternating with
A
“0”
. If within
“B”
Loading...