Whirlpool AKP 983 NB, AKP 972 NB, AKP 987 NB, AKZ 358 NB, AKZ 367 NB User Manual
...
3gb66016.fm5 Page 1 Tuesday, April 16, 2002 3:27 PM
INSTRUCTION FOR USE
INSTALLATION
ELECTRICAL CONNECTION
BEFORE USING THE OVEN
HINTS FOR PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL SUGGESTIONS
OVEN ACCESSORIES
CLEANING THE OVEN AND ITS ACCESSORIES
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
DECLARATION OF CONFORMITY CE
1
3gb66016.fm5 Page 2 Tuesday, April 16, 2002 3:27 PM
INSTALLATION
Technical information for the installer
Unpack the oven to make the connections.
Rest the oven on the polystyrene base to avoid damaging it.
Do not lift the oven by the door handle, but hold it at the sides.
Make sure that the appliance has not been damaged during transport.
The dimensions of the oven and the unit are given in the picture below.
Units in contact with the oven must be heat resistant (90°C).
If plastic laminates or the sealing material are not sufficiently heat resistant, bubbles may
form, the surface may be deformed or the coating may detach.
House the oven in the unit cavity, lifting it at the sides and making sure that the supply
cable is not trapped.
To ensure correct ventilation, respect the ventilation openings indicated in the picture
(200 mm
Fasten the oven to the unit with the screws (A) as shown.
The oven can also be fitted under a cooktop.
2
minimum).
*
: 590 For D+CH only
*
A
A
A
There must be a gap of at least 5 mm between the upper edge of the oven and the lower
edge of the working surface. This gap must never be closed by strips or unit reinforcing
pieces. When the oven is installed, make sure that the sides do not touch the front edges
of the unit or the adjacent drawers and door (see below picture).
A
No Contacts
2
3gb66016.fm5 Page 3 Tuesday, April 16, 2002 3:27 PM
ELECTRICAL CONNECTION
Do not switch on the oven before connection is
complete.
Make sure that the installation and the electrical
connection are made by a qualified engineer
according to the manufacturer's instructions and the
local rules in force.
The installer is responsible for the correct electrical
connection and for observance of the safety rules.
The appliance must be connected to the main outlet
by means of an omnipolar switching device with a
contact opening distance of at least 3 mm.
Grounding appliances is mandatory by law.
Do not use multiple sockets or extensions.
After the installation, the electrical parts must be
inaccessible.
Make sure that the voltage stated on the appliance
rating plate is the same as the voltage in your home.
The rating plate is on the front edge of the oven
(visible when the door is open).
BEFORE USING THE OVEN
For best use of the oven please read the
instructions for use carefully and keep
them in a safe place.
Remove the cardboard protection and the
protective plastic film.
Take the accessories out of the oven and
heat it to 200°C for about an hour to
remove the smells and fumes of insulating
material and protective greases. Keep the
window open during this operation.
HINTS FOR PROTECTING THE ENVIRONMENT
1. Packing
The packaging material is 100% recyclable
and it is marked with the recycle symbol
().
2. Electrical appliances
The electrical appliances are manufactured
with recyclable or reusable material.
Dispose of them following the local
regulations for the disposal of waste.
Before disposing of them make them
unusable by cutting off the supply cable.
3
Loading...